Instruction Manual

Thank You

Thank you for purchasing this product. To achieve the perfect hidden-line effect, we use extremely thin aviation-grade wire with high tension and pressure tolerance. However, due to its thin nature, be careful not to cut through it as it might be susceptible to shearing during installation. Always be careful not to press brick pieces down on the wire.

Let's Get Started

If you face any challenges, please feel free to reach out via support@gameofbricks.eu. Game of Bricks offers 2 years of free light kit maintenance.

Step 1 (Bag 1)

This step involves preparing and installing the front lights and associated wiring for the Nissan Skyline GT-R (R34) model.

Components: Bag 1 contains small LED lights and thin wires.

Procedure:

1. Place the LEGO model of the Nissan Skyline GT-R (R34) on a flat surface.
2. Carefully insert the small LED lights into the designated headlight positions at the front of the car.
3. Route the thin wires from the LEDs through the model, following the paths indicated in the visual guides. Ensure wires are not pinched or cut by brick edges.
4. Attach specific front-facing brick components that house the LEDs and wires.
5. Connect the wires to a small circuit board or connector strip, typically located underneath the model.
6. Secure the front section of the car, ensuring all wires are neatly tucked away and not obstructing any moving parts or connections.

The underside of the model will show the routing of wires and the connection points for the front lighting elements.

Step 2 (Bag 2)

This step focuses on installing the rear lights and related wiring.

Components: Bag 2 contains LED lights and wires for the rear of the car.

Procedure:

1. Prepare the rear section of the LEGO model.
2. Insert the small LED lights into the taillight assemblies at the back of the car.
3. Route the wires from the rear LEDs through the chassis of the model.
4. Attach the rear bumper and taillight brick assemblies, ensuring the wires are correctly positioned.
5. Connect the wires to the appropriate points, likely leading towards the central wiring harness or power distribution board.
6. Secure the rear components, making sure the wires are managed to prevent damage.

The process involves carefully placing and connecting small components and wires to the rear of the vehicle.

Step 3 (Bag 3)

This step involves connecting the lighting system to the power source and completing the internal lighting.

Components: Bag 3 includes a USB power cable and potentially additional LEDs or connectors.

Procedure:

1. Access the interior or underside of the model where the main wiring harness is located.
2. Connect the wires from the front and rear lights to the central distribution board or connector.
3. Install any interior lighting elements if included in this step.
4. Route the main power cable (USB cable) from the distribution board to an accessible point on the model, usually the underside or rear.
5. Carefully reassemble any interior or exterior parts of the car that were removed to facilitate wiring.
6. Connect the USB cable to a suitable power source.

The final step involves connecting the entire lighting system to a power source, such as a battery box or USB power adapter, to illuminate the model.

Final Connection

Connect the light kit to the battery box, and the installation will be complete. If you wish to use another power source, please ensure the maximum voltage is 6V.

Product Information

Model Number: 8018

This manual pertains to the light kit for the LEGO 2 Fast 2 Furious Nissan Skyline GT-R (R34).