Submittal Data Sheet: HMH7 Series - 17 SEER Horizontal Discharge Modulating Heat Pump

Submittal Data

Job name:

Purchaser:

Engineer:

Submitted to: For: Ref:

Submitted by: Approval: Construction:

Unit designated: Date: Schedule number: Model number:

Location: Order number:

Product Data

Cooling Performance

Total capacity: ______________________ MBH

Outdoor design temperature: ______________________ °F

Heating Performance

Total capacity: ______________________ MBH

Outdoor design temperature: ______________________ °F

Electrical Data

Power supply: ________/_______/_______

Compressor ampacity: ______________________ A

Total unit ampacity: ______________________ A

Power input requirement: ______________________ kW

Minimum wire size: ______________________ AWG

Maximum overcurrent device: fuses [circuit breaker]

Weight

Unit weight: ______________________ lb

Dimensions

Table 1: Dimensions

Note:

• All dimensions are in inches and are subject to change without notice.
• Overall length and width include screw heads.

Figure 1: Dimensions

Diagram showing the outdoor unit with dimensions labeled A, B, and C, and refrigerant connections for liquid and vapor lines with their service valve sizes.

Certification

The units are tested in accordance with the following:

• ETL Listed (Intertek)
• AHRI Certified (Unitary Small HP, AHRI Standard 210/240) - Certification applies only when the complete system is listed with AHRI.
• ISO 9001 Registered Quality Management System

Warranty Summary

• Extended 10-year limited parts warranty.
• Extended 10-year limited compressor warranty.
• Extended parts and compressor warranties require online registration within 90 days of purchase for replacement or closing for new home construction.
• Warranty does not apply to R-22 models, 3-phase models, or Internet sales.
• See the Limited Warranty certificate in the User's Information Manual for details.

Features

• 360 DC inverter driven technology: Optimizes energy usage, compressor stability, and provides quiet operation and precise temperature control across operating conditions.
• Pressure sensor: Protects the system from damage by detecting low pressure (cooling) and high pressure (heating). Enables intelligent control by calculating indoor coil temperature from system suction pressure.
• Smaller outdoor form factor for installation flexibility: Side-discharge outdoor unit saves approximately 35% space over traditional units, allowing wall, yard, or roof installation.
• Stable temperature control means optimal comfort: DC inverter provides full capacity at startup for rapid cooling/warming and adjusts speed to prevent temperature fluctuation and energy loss.
• Agency Listed: Safety certified by CSA to UL 1995/CSA 22.2. Performance certified to ANSI/AHRI Standard 210/240.

Minimum Clearances

Figure 2: Minimum Clearances When Selecting a Location

Diagram illustrating required minimum clearances around the outdoor unit for proper installation and airflow. Clearances specified for 24k/36k models are over 12 inches (300 mm) on one side, and for 48k/60k models are over 24 inches (600 mm) on the same side. Other clearances include over 6 in. (150 mm), over 8 in. (200 mm), over 20 in. (500 mm), and over 14 in. (350 mm) on other sides.

Matching Air Side Equipment & Field Installed Accessories

Matching air side equipment

Model number: __________________________________

Submittal form number: _________________________

Field Installed Accessories

• H Series - Horizontal Discharge Modulating Heat Pump Compatibility Kit (HMH7AK001): Required for proper function of the H Series outdoor section when outdoor terminal S1 is energized.
• TXV Kits (S1-1TVM*): Thermal expansion valves that precisely meter refrigerant for optimum performance over a wide range of conditions.