Important Safety Information
WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.
Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.
(Note: Warnings are also provided in Hebrew.)
Assembly Steps
Step 1
Attach the 6 feet (Part 1, numbers 114947, 115988) to the underside of the bottom panel. Insert the threaded part of the feet into the pre-drilled holes and twist to secure.
Step 2
Insert 12 cam bolts (Part 3, number 130618) into the designated holes on the edges of the bottom and top panels.
Step 3
Attach the side panels (Part 10) to the bottom panel. Align the cam bolts on the bottom panel with the corresponding holes on the side panels. Insert cam locks (Part 4) into the large holes on the inside of the side panels and turn them clockwise to secure the panels to the bottom panel.
Step 4
Insert 4 cam locks (Part 4) and 4 cam bolts (Part 3, number 130618) into the side panels. Attach the back panels (Part 11) by sliding them into the grooves on the side and bottom panels. Secure with cam locks.
Step 5
Attach the wall attachment bracket (Part 9, number 144342) to the top panel using 2 screws (Part 5, number 113287). Ensure the bracket is oriented correctly.
Step 6
Insert the back panels (Part 11) into the grooves of the assembled frame. Ensure they are fully seated.
Step 7
Attach the top panel (Part 14) to the assembled sides and back panels. Align cam bolts with holes and secure using cam locks (Part 4) as shown in the diagram.
Step 8
Insert the internal dividers (Part 15) into the unit. Align them with the pre-drilled holes and secure them using the provided hardware.
Step 9
Place the top panel onto the assembled unit. Secure it by inserting screws from the top into the side and divider panels. The diagram shows arrows indicating insertion points.
Step 10
Turn the unit upright. Attach the remaining cam locks (Part 4) to secure the top panel to the side panels and internal dividers.
Step 11
Assemble any drawer or door components if applicable. The diagram shows a folding mechanism for a drawer front.
Step 12
Slide in any shelves or drawer runners. The diagram shows a shelf being inserted.
Step 13
Attach any additional mounting brackets or supports. The diagram shows attaching brackets (Part 9, number 144342) to the top panel using screws (Part 7, number 109049).
Step 14
Route any cables through the designated openings and clips. The diagram shows cables being managed through the back of the unit.
Step 15
Secure cables using the provided clips (Part 19). The diagram shows clips being attached and cables snapped into place with an audible 'Click!' sound.
Step 16
Attach the unit to the wall using the wall attachment hardware (Part 18, number 103693) and the provided bracket (Part 9, number 144342). Use the Allen key (Part 8, number 100006) to adjust the feet for leveling.
Step 17
Ensure the unit is stable and level. The diagram shows adjusting the feet using the Allen key and checking for stability.
Step 18
Attach doors or drawers. The diagram shows attaching hinges and then securing them with screws. The wall mounting bracket (Part 18, number 103693) is shown being attached to the wall, and then the unit is connected to it. A 'Click!' indicates successful attachment.
Step 19
Install shelves using shelf supports (Part 12, 115444 and Part 13, 115443). Insert the supports into the desired holes on the side panels and internal dividers, then place the shelves on top.
Step 20
Final check of all connections and stability. The copyright information is provided: © Inter IKEA Systems B.V. 2014.
