BAGGEBO TV Bench Assembly Instructions

Important Safety Warning

⚠️ WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided. Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instructions carefully.

Parts List

• Dowel (Part 101339): 1x
• Dowel (Part 101345): 9x
• Connector (Part 106940): 2x
• Connector (Part 100481): 2x
• Cam lock (Part 103430): 4x
• Cam lock screw (Part 119252): 2x
• Screw (Part 100229): 8x
• Screw (Part 109041): 1x
• Washer (Part 100823): 2x
• Wall bracket (Part 106989): 1x
• Wall attachment part (Part 100823): 1x (This refers to the washer used with the bracket in step 18)
• Bag of nails/pins (Part 319503): 1x
• Divider support (Part 105494): 1x
• Foot (Part 122628): 6x
• Allen key (Part 100006): 1x

Assembly Steps

1. Step 1: Insert one dowel (101339) into the pre-drilled hole on a panel.
2. Step 2: Attach two connectors (106940) to another panel.
3. Step 3: Insert four cam locks (103430) into the designated holes on a panel.
4. Step 4: Insert the panel from Step 2 into the panel from Step 3, aligning the connectors.
5. Step 5: Insert two cam locks (103430) into the designated holes on the assembled structure.
6. Step 6: Insert five dowels (101345) into the pre-drilled holes on the side panels.
7. Step 7: Attach the wall bracket (106989) to a panel using one screw (109041) and one washer (100823).
8. Step 8: Attach two connectors (100481) to a panel.
9. Step 9: Insert four dowels (101345) into a panel.
10. Step 10: Assemble the main frame by connecting the panels.
11. Step 11: Insert two cam lock screws (119252) and tighten the cam locks (103430) to secure the panels.
12. Step 12: Insert the side panels into the main structure.
13. Step 13: Secure the structure using four screws (100229) with the Allen key (100006).
14. Step 14: Slide the back panel into the grooves of the assembled unit.
15. Step 15: Secure the back panel using four screws (100229).
16. Step 16: Attach the divider support (105494) to the inner panels using 14 pins (101221) and a hammer. ⚠️ Ensure the pins are inserted correctly and the support is flush.
17. Step 17: Attach the six feet (122628) to the bottom of the unit using a hammer.
18. Step 18: Attach the wall mounting hardware. Secure the bracket (106989) to the unit using one washer (100823) and screw (109041). Then, attach the corresponding wall fixing part (not explicitly numbered but shown with part 100823). ⚠️ Ensure the furniture is securely fastened to the wall using appropriate wall plugs and screws suitable for your wall type.