ALLMATIC SO400/IT Electromechanical Swing Gate Operator
1. Features and Specifications
The SO400/IT ram is manufactured in RIGHT and/or LEFT versions, depending on the gate leaf to which it will be installed. The leaves should be viewed from the inside (garden side). The SO400/IT cylinder is designed for easy installation on any type of gate, provided it is well-balanced. The SO400/IT cylinder, with a 400mm stroke, is built for gate leaves not exceeding 350 kg in weight and 3 meters in length.
Technical Features
| Feature | Specification |
|---|---|
| Power Supply | 230 Vac |
| Power | 280 W |
| Absorbed Current | 1.8 A |
| Rod Speed (cm/s) | 1.8 |
| Usable Stroke | 400 mm |
| Max Leaf Length | 3 m |
| Max Leaf Weight | 350 Kg |
| Maximum Thrust | 2800 N |
| Protection Class | IP44 |
| Thermal Protection | 150°C |
| Cycles per Hour | 18 |
| Operating Temperature | -20°C to +70°C |
| Lubrication | Ferrograf permanent |
| Capacitor | 8µF |
| Motor Weight | 6 Kg |
Dimensions
The SO400/IT operator has specific dimensions for different rotation angles:
| Stroke | 95° Rotation (mm) | 110° Rotation (mm) | ||||
|---|---|---|---|---|---|---|
| W | X | Y | W | X | Y | |
| 400 | 1130 | 160 | 210 | 1130 | 170 | 160 |
Overall Length (L): 766 mm. Other dimensions indicated are 187 mm and 95 mm.
Diagrams illustrate the mounting points (Fig.A), gate stops (Fig.B), and dimensional details (Fig.C).
2. Installation
Follow these steps for installation:
- Fix the large plate to the column, adhering to the measurements specified in the table. Position the cylinder perfectly horizontally (level) with respect to its axis (refer to Fig.A).
- Attach the gear-motor to the large plate (labeled "1") using the supplied pin and grub-screw.
- Fully extend the stainless steel tube (labeled "3") to the end of its stroke. Then, screw it back by one turn (at least 1 cm) to ensure the gate leaf closes perfectly.
- Secure the small plate (labeled "4") to the end of the cylinder using the provided pin and grub-screw. Attach this small plate to the gate leaf, ensuring the cylinder remains horizontal (level).
- Position the mechanical doorstops for both the open and closed gate positions (refer to Fig.B).
Fig.A shows the gate setup with the pillar, gate hinge, large bracket (1), unlocking device (2), stainless steel tube (3), and small plate (4). Fig.B illustrates the gate opening and closing with mechanical stops. Fig.C details the mounting plates and dimensions.
3. Manual or Emergency Manoeuvre
To perform a manual or emergency manoeuvre, operate the unlocking device (labeled "2") using the key provided.
Warranty
The manufacturer's guarantee is valid from the date stamped on the product and is limited to the repair or free replacement of parts recognized as defective due to essential material quality or manufacturing defects. The guarantee does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, incorrect product selection, assembly errors, or other causes not attributable to the manufacturer. Tampered products will not be guaranteed or repaired. Specifications are indicative; the manufacturer is not responsible for range reductions or malfunctions due to environmental interference. The manufacturer's responsibility for damages caused to persons resulting from accidents of any nature caused by defective products is limited by Italian law.
