2607110 RS2607110 Bluetooth Selfie Operation Instructions
Operation Instructions
Power On
Press and hold the camera button for 3 seconds.
Bluetooth Selfie and Phone Connection Steps
-
Step 1: Pairing Initiation
Press and hold the Bluetooth selfie camera button for 3 seconds to turn on the device. The LED indicator light flashes, and the Bluetooth selfie starts pairing with the phone.
Image Description: A physical Bluetooth selfie remote device is shown.
Image Description: The phone's Bluetooth settings screen displays "RS2607110" under the "Available Devices" section.
-
Step 2: Bluetooth Pairing Request
Press and hold the Bluetooth selfie camera button for 3 seconds to turn on the device. The LED indicator light flashes, and the Bluetooth selfie starts pairing with the phone.
Image Description: The phone's Bluetooth pairing request screen shows a prompt for "RS2607110". It includes an option to "Allow access to contacts and call logs" and buttons for "Cancel" and "Pair".
-
Step 3: Connection Confirmation
The "Paired Devices" page displays "KJ remote connected", indicating the Bluetooth selfie is successfully connected to the phone.
Image Description: The phone's "Paired Devices" screen lists "RS2607110" as "Connected".
Device Information
- Bluetooth name: RS2607110
- Connection distance: At least 10 meters.
Taking Photos
After successfully pairing the Bluetooth selfie, press the photo button once. The LED indicator light will flash, and the phone will take photos.
Sleep Mode and Disconnection
- After 3 minutes of booting up, if pairing was not successful, the LED indicator light flashes twice before turning off, and the Bluetooth selfie enters sleep mode.
- After 5 minutes of successful connection with no operation, the LED indicator light flashes twice before turning off. The Bluetooth selfie disconnects from the phone and enters sleep mode.
- After restarting, the device automatically connects without needing to re-pair.
Shutdown
Press and hold the camera button for 3 seconds. The LED indicator light flashes quickly twice and then turns off, disconnecting the Bluetooth selfie and phone.
FCC Compliance and Warnings
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
FCC Class B Compliance
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Troubleshooting Interference
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
NOTE: This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter. The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.
