Renogy COMPACT-SUITCASE Portable Solar Panel

Applicability

This User Manual applies to the following Renogy COMPACT-SUITCASE Portable Solar Panel models:

• COMPACT-SUITCASE 100 Portable Solar Panel (RSP100LSC)
• COMPACT-SUITCASE 220 Portable Solar Panel (RSP220LSC/RPP220LSC-VY20)
• COMPACT-SUITCASE 300 Portable Solar Panel (RSP300LSC)
• COMPACT-SUITCASE 400 Portable Solar Panel (RSP400LSC)

Disclaimer

Renogy ensures the accuracy, sufficiency, and applicability of information at the time of printing, subject to ongoing product improvements. Renogy is not responsible for losses or damages resulting from improper installation, use, or repair attempts by unqualified personnel. Illustrations are for demonstration purposes and may vary slightly. Renogy reserves the right to change information without notice.

Copyright

COMPACT-SUITCASE Series Portable Solar Panel User Manual © 2025 Renogy. All rights reserved. All content is protected by copyright and intellectual property rights of Renogy and its licensors. Reproduction or modification without prior written permission is prohibited.

Trademarks

The following are trademarks or registered trademarks of Renogy worldwide:

[Renogy Logo]

Other trademarks belong to their respective owners and their use does not imply endorsement. Unauthorized use of trademarks is strictly prohibited.

Symbols Used

The following symbols highlight important information:

• ⚠️ WARNING: Indicates a potentially dangerous condition which could result in injury or death.
• ❗ CAUTION: Indicates a critical procedure for safe and proper installation and operation.
• ? NOTE: Indicates an important step or tip for optimal performance.

General Safety Information

⚠️ WARNING

• DO NOT disassemble the unit or remove any attached components.
• DO NOT puncture, drop, crush, penetrate, shake, strike, or step on the COMPACT-SUITCASE.
• DO NOT open, dismantle, repair, tamper with, or modify the COMPACT-SUITCASE.
• DO NOT place the unit on a surface constructed from combustible material.
• DO NOT expose the COMPACT-SUITCASE to direct flame or heat sources.
• Keep the unit out of reach of children unless supervised by an adult.
• Keep the unit away from explosives and corrosive substances.

❗ CAUTION

• DO NOT step, walk, stand, or jump on the unit. Localized heavy loads can damage the solar cells, compromising performance.
• DO NOT band the unit, as this may break the panel.
• DO NOT immerse the unit in water.
• Dispose of the unit according to local recycling and environmental regulations.
• For details on using included hooks (controller version), refer to 'Portable Module Hook Installation' on the product details page at renogy.com.

Package Contents

• 1 x Renogy COMPACT-SUITCASE Portable Solar Panel
• 1 x Case
• 1 x User Manual
• 1 x Controller hook (controller version only)

Installation

1. Open the packaging bag, grasp the handles and pull upwards to extract the COMPACT-SUITCASE section and raise the brackets to their maximum positions. (Illustration shows opening a bag, pulling handles, and extending foldable brackets.)

2. Fully unfold the COMPACT-SUITCASE and place it on the ground. (Illustration depicts the COMPACT-SUITCASE solar panel fully unfolded and placed on a flat surface.)

3. Adjust the angle of the brackets to ensure stability, with the lighting surface facing towards the sun. (Illustration shows the solar panel angled towards the sun. A sun graphic indicates the light source.)

Operation

How to charge a power station

1. Place a solar panel under direct sunlight. Avoid objects that can shade the panel and slow down charging.

2. Connect the solar connectors of the solar panel to the solar charge cable (sold separately), then connect to the DC input port of the power station. (Diagram illustrates connecting a solar panel array via a solar charge cable to the DC input port of a portable power station.)

? The solar charge time is highly dependent on solar irradiance and ambient temperature.

? The operating voltage of the solar panel shall exceed the minimum DC-input voltage of the power station and shall NOT exceed the maximum DC-input voltage.

How to charge a battery

1. Connect the COMPACT-SUITCASE connector to the PV Terminals of a charge controller (sold separately).

2. Connect the BATT Terminals of the charge controller to battery terminals using tray cables (sold separately).

3. Set the charging parameters on the charge controller. The COMPACT-SUITCASE is now ready to charge a battery. (Diagram shows a solar panel array connected to a charge controller, which is then connected to a battery.)

How to connect COMPACT-SUITCASE in series/parallel

To expand power output, COMPACT-SUITCASE panels can be connected in series or parallel.

Series Connection: (Diagram shows two COMPACT-SUITCASE panels connected in series to a power station.)

Parallel Connection: (Diagram shows multiple COMPACT-SUITCASE panels connected in parallel using MC4Y connectors to a power station.)

Specifications

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Renogy Support

To discuss inaccuracies or omissions in this quick guide or user manual, visit or contact us at:

• ? renogy.com/support/downloads
• ✉️ contentservice@renogy.com

Questionnaire Investigation: [QR code for questionnaire investigation]

To explore more possibilities of solar systems, visit Renogy Learning Center at:

• ? renogy.com/learning-center

For technical questions about your product in the U.S., contact the Renogy technical support team through:

• ? renogy.com/contact-us
• ? 1(909)2877111

For technical support outside the U.S., visit the local website below:

Renogy Empowered

Renogy aims to empower people around the world through education and distribution of DIY-friendly renewable energy solutions. Renogy intends to be a driving force for sustainable living and energy independence. By using Renogy's solar products, users can minimize their carbon footprint by reducing the need for grid power.

Live Sustainably with Renogy

Did you know? In a given month, a 1 kW solar energy system can help:

• Save approximately 77 kg of coal from being burned.
• Reduce CO2 emissions by approximately 136 kg.
• Conserve approximately 397.5 liters of water.

Renogy Power PLUS

Renogy Power Plus allows users to stay updated on solar energy innovations, share their solar journey experiences, and connect with like-minded individuals making a difference in the Renogy Power Plus community.

[YouTube Icon] @Renogy Solar | [Instagram Icon] @renogyofficial | [Facebook Icon] @Renogy