OEDRO Tri-Fold Hard Tonneau Cover Assembly Instructions
Important Safety and Usage Guidelines
Always secure the latches ?.
Do not overload cargo ⚖️.
Use seal strips for exposed gap ?.
Remove all items including snow before folding the panels ❄️.
We recommend checking the cover is securely attached to the truck bed periodically. Look for any loose bolts and handles due to road vibration or cargo contact.
Use a sponge or soft cloth with water to gently remove any dust or dirt from the surface.
The warranty covers defects in materials, missing items, and workmanship of this product.
Damages resulting from improper installation, modification, misuse, repair, or use other than intended design, including normal wear and tear, vehicle accidents, or acts of God, are not covered by the warranty.
The warranty applies only to the original purchaser and does not cover subsequent owners or purchasers. Proof of original purchase is required for any warranty services.
OEDRO is not responsible for incidental or consequential damages, such as injury or loss, caused by improper use.
Professional installation is highly recommended.
1. Products Inventory
Included Components:
- Tonneau Cover * 1
- Front Clamps * 2
- Handles * 4
- Aluminum Buckles * 2
- Knobs * 2
- Seal Strip * 16
- Hex key 3.0mm * 1
- Hex Socket Cap Screws * 4
- Bag Buckles Mounts * 2
- Bag Buckles * 10
- Plastic Sliding * 2
- Buckle Holder * 1
- Hex key 2.5mm * 1
- Set Screws * 12
Optional Accessories (for Jeep/Toyota/Nissan with utility track):
- Aluminum Blocks * 6
2. Installation Guide
Step 1: Prepare the Truck Bed
Stick the seal strip on the front of the truck bed. Cut down the strip parts on the two junction steps between the bulkhead and the side bed. Finally, cut the strip a little longer than the length of the bulkhead bed. Ensure there is no gap between the strip and the corner of the tonneau cover.
Step 2: Position the Tonneau Cover
Place the tonneau cover on the front of the truck bed and adjust its position to the center.
Step 3: Secure the First Panel
Insert the Knob and Aluminum Buckle through the T-bolt to assemble a fixed clamp in the first panel near the bulkhead. Spin the knob and tighten the buckle to lock it onto the truck bed rails.
Step 4: Attach Clamp Handles
Insert the handle through the T-bolts to assemble as a clamp handle. Unfold the second cover.
Step 5: Secure the Clamps
Spin the clamp handles up and push down the handle to ensure the lip is locked on both sides of the truck bed rails. Ensure the handles are secure and tight on the bed rails. Then unfold the third cover without the fixture. (If it is a triple cover, proceed to Step 6 directly.)
Step 6: Secure Remaining Panels
Repeat the procedure from Step 4 for the last cover. Sometimes the seal strip in the last panel may wrinkle during transportation; pull it higher during initial installation for better water resistance. Close the tailgate to check whether the cover lays flat or if there are any gaps between the cover and the bed.
3. Long Bed Liner Tips
4. Vehicles with Utility Track (Toyota/Nissan/Jeep)
Slide the aluminum blocks into the track, then adjust their position and tighten the set-screws.
Secure the six clamps on the aluminum blocks.
Finished Look
The tonneau cover should now be securely installed, providing a finished and protected truck bed.
