OEDRO OFF-ROAD 4X4 DIY

Tools Required

• 19mm, 16mm, 13mm Socket
• 6mm, 5mm Hex Bit
• Ratchet
• Torque Wrench

Notes

• Read these instructions carefully before starting installation.
• The bull bar is designed to fit a 16"-20" side mount LED light bar.
• The pretreated trim panel can be removed for customized painting.
• If any parts are missing or any damage is found, please take a picture and contact OEDRO.

Installation Steps

Step 1: Remove Original Bumper

1. Remove four (4) rivets holding the splash guard and detach the splash guard.
2. Remove two (2) rivets securing the frame cover between the grille and the front bumper.
3. Disconnect fog lamp connectors.
4. Remove eight (8) M12 hex nuts holding the original bumper onto the frame rail.
5. Carefully remove the original front bumper.

[Diagram Description: Shows the front of a vehicle's bumper area. Arrows indicate the removal of rivets from a splash guard and a frame cover. Electrical connectors for fog lamps are shown being unplugged. Bolts securing the original bumper to the frame rails are indicated for removal.]

Step 2: Install Fog Lamps

1. Remove factory fog lamps from the old bumper.
2. Install the factory fog lamps to the OEDRO front bumper using the factory mounting hardware.

Step 3: Attach Bull Bar

1. Position the bull bar to the OEDRO front bumper.
2. Secure the bull bar using six (6) M8 button head bolts, six (6) M8 flat washers, and six (6) M8 hex nuts.
3. Tighten the M8 hardware to 15 ft. lbs. torque.

[Diagram Description: Illustrates the OEDRO front bumper assembly. The bull bar is shown being aligned with specific mounting points on the bumper. Bolts, washers, and nuts are depicted being inserted through the bull bar and bumper.]

Step 4: Attach Winch Plate

1. Position the winch plate to the OEDRO front bumper.
2. Secure the winch plate using four (4) M10 button head bolts, four (4) M10 flat washers, and four (4) M10 hex nuts.
3. Tighten the M10 hardware to 31 ft. lbs. torque.

[Diagram Description: Shows the OEDRO front bumper assembly with the winch plate being attached to its designated mounting area. Bolts, washers, and nuts are shown securing the winch plate to the bumper.]

Step 5: Mount Bumper Assembly to Frame

1. With assistance, lift and attach the assembled bumper to the vehicle's frame rails.
2. Secure the bumper assembly using eight (8) M12 flat washers and eight (8) M12 hex nuts.
3. Tighten the M12 hex bolts to 60 ft. lbs. torque.

[Diagram Description: Depicts the main OEDRO bumper assembly being lifted and aligned with the vehicle's frame rails. Bolts and washers are shown being used to attach the bumper to the frame, with torque specifications mentioned.]

Step 6: Install Accessories and Final Checks

1. Position the license plate bracket to the winch plate.
2. Secure the license plate bracket with two (2) M10 button head bolts, two (2) M10 flat washers, and two (2) M10 hex nuts.
3. Connect the fog lamp connectors.
4. Install two (2) D-rings onto the shackle mounting brackets.
5. After the bumper is installed, perform periodic checks to ensure all mounting hardware remains secure and tight.

[Diagram Description: Shows the license plate bracket being bolted to the winch plate. Fog lamp connectors are depicted being plugged in. D-rings are shown being attached to their respective mounting points on the bumper.]

Part List