Tow-Trust Towbars
[wrench] Important: Please read General Notes overleaf before fitting
Issue 3
TC715VK Mitsubishi Outlander 2007 - 2012
Peugeot 4007 2007>
Citroen C Crosser 2007>
Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | Crossmember | K | 2 | M12 x 22 Bolts & S/P Washers |
| B | 1 | R/H Side Plate | L | 10 | M10 x 40 x 1.25 Bolts & S/P Washers |
| C | 1 | R/H Angle Bracket | M | 2 | M12 x 22 Bolts & S/P Washers |
| D | 1 | L/H Shaped Angle Bracket | N | 2 | M14 x 45 Bolts & Nyloc Nuts |
| G | 1 | Extension Housing | P | 4 | 12 x 25 Flat Washers |
| J | 1 | TTFP/LH (14mm Hole) | R | 4 | 14 x 27 Flat Washers |
| S | 10 | 10 x 30 Flat Washers |
Installation Instructions
Diagram Reference: The installation involves fitting the towbar assembly (A) to the vehicle chassis using various brackets (B, C, D) and fasteners. An extension housing (G) with a tow ball (J) is attached to the main crossmember (A). A specific cut is required on the vehicle's rear bumper, approximately 45mm x 45mm, indicated by a centre line.
- Lower the spare wheel.
- Cut a section centrally from the lower edge of the bumper. If required, trim to suit.
- Temporarily remove all fixings from the lower edge of the bumper. Note: Bend the central bumper tag out of the way to gain access for the towbar.
- Remove the rearmost exhaust rubber. Note: It is advisable to support the exhaust during this process to prevent damage.
- Using L with S, loosely bolt B through the central hole only to the existing threaded hole in the lower face of the right-hand chassis member.
- Using L with S, loosely bolt C through existing threaded holes in the side face of the chassis and through B into existing threaded holes in the lower face of the chassis.
- Carefully locate A into the rear bumper and using L with S, loosely bolt through the central hole only to the existing threaded hole in the lower face of the left-hand chassis member.
- Using N with R, loosely bolt A with J to B.
- Using L with S, loosely bolt D through existing threaded holes in the side face of the chassis and through A into the existing threaded holes in the lower face of the chassis.
- Fully tighten all nuts and bolts and ensure the towbar is rigid and secure.
- Using M with P and K with P, bolt G to A.
- Fully tighten M and K securing the extension housing.
- Refit exhaust rubber.
- Replace spare wheel.
- Replace fixings in the lower edge of the bumper.
Notes
- Recommended Torque Setting for M12 Grade 10.9 -139 Nm. (For other Torque Settings see notes overleaf.)
- Nose load limits and vehicle manufacturer's trailer / caravan weight limits must be observed.
