Lian Li Galahad II Trinity SL-INF 240/360 Installation Guide
Feel the difference
Hardware List
The following components are included in the hardware list:
- A: Mounting screw (x1)
- B: Thermal paste applicator (x1)
- C: Thermal pads (x2)
- D: Screws for mounting (x2)
- E: LGA 1700 mounting bracket (x1)
- F: Mounting bracket (x1)
- G: Intel mounting bracket (x1)
- H: Intel mounting bracket (x1)
- I: Fan screws (x4)
- J: Pump cover rings (x1)
- K: Pump cover rings (x1)
- L: Pump cover rings (x1)
- M: ARGB cable (x1)
- N: Controller hub (x1)
- O: ARGB cable (x1)
- P: SATA power cable (x1)
- Q: Magnetic adhesive pads (x1)
- R: ARGB cable (x1)
- S: Mounting screw (x4)
Installation Instructions
Follow these steps for installation:
Apply Thermal Paste
Apply thermal paste to the CPU. The direction of the control film depends on the CPU orientation. Ensure correct placement as shown in the diagrams.
Default Orientation: The pump is in its default orientation.
Rotate Orientation: Rotate the pump to change its orientation.
Intel LGA1700/115X/1200 Mounting
- Apply thermal paste.
- Attach the correct mounting brackets (G, H) for your Intel socket.
- Use the provided screws (S) to secure the brackets.
- For LGA 1700, use the outer way mounting. For 115X/1200, use the inner way mounting.
- Ensure the mounting brackets are facing downwards.
AMD AM4 Mounting
- Apply thermal paste.
- Secure the AMD latch onto the platform's retention clip and tighten with the spring nut.
- Use the provided screws (S) to secure the cooler.
- The cooler supports two outlet orientations for the tubes.
Mount in the Chassis
Mount the radiator and fans to your PC case using the provided screws (D for 240mm, 360mm variants). Ensure proper airflow.
Customize Pump Cover
Personalize the pump cover by choosing from different ring designs (J, K, L). Follow the instructions to attach the desired cover.
- DEFAULT: Use the default pump cover.
- Duo-Infinity: Install the 'Duo-Infinity' ring.
- Dazzle: Install the 'Dazzle' ring.
Remember to peel the protective film from the chosen ring before installation.
Install Inner and Outer Covers
Install the inner cover (K) and outer cover. Ensure the latch is correctly positioned and twist the covers to secure them.
Important: Place the latch in the suitable slot and twist the outer cover to install properly. For the inner cover, place the latch in the slot and twist to install.
Cable Connection
Connect the pump and fans to the controller hub (N) and then to the motherboard and PSU.
- Pump Cable (M): Connect to the controller hub. Ensure the convex side faces upward.
- ARGB Cables (O, R): Connect to the controller hub and motherboard's ARGB header.
- Power Cable (P): Connect to the PSU via SATA power.
- Fan Cables: Connect to the controller hub.
Warning: Do not connect the wrong type of LED connector. Connecting to a 12V connector will cause permanent damage. Use the 5V ARGB 3-pin header.
Controller Restriction: The controller has a maximum output of 22.5W. For static white lighting, lower the brightness. The controller supports up to 6 UNI FAN SL-INF fans for synchronized lighting effects.
Fan Removal
To remove a fan, release the latch and slide the fan out.
Cable Orientation
Follow the steps to switch the orientation of the cable on the power module.
Magnetic Adhesive Use
Use the magnetic adhesive pads (Q) for mounting components as needed. Remove the adhesive backing before application.
