Ergotron
User's Guide
Replace Battery
for StyleView® SV32 & SV42 Carts with LiFe Power System
Maintenance & Safety
Hazard Symbols Review
These symbols alert you to a safety condition that demands your attention. You should be able to recognize and understand the significance of the following Safety Hazards if you encounter them on the Cart or within Cart documentation such as this Set-up Guide.
| Color | Symbol | Signal Word | Level of Hazard |
|---|---|---|---|
| Red | ! | DANGER | Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. |
| Orange | ! | WARNING | Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. |
| Yellow | ! | CAUTION | Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. |
| None | ! | CAUTION | Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. |
| Red, Orange or Yellow | ⚡ | Electrical | Indicates an impending electrical hazard which, if not avoided, may result in personal injury, fire and/or death. |
WARNING: RISK OF ELECTRICAL DISCHARGE
- Do NOT swap battery cables, doing so will cause arcing and trip the circuit breaker.
- Do not remove or replace the batteries while cart is located in an oxygen rich or hazardous environment, arcing may occur and cause combustion.
CAUTION: To avoid risk of electrical shock when replacing battery:
- Remove Black (-) cable from post before removing Red (+) cable from post.
- Connect Red (+) cable to post before connecting Black (-) cable to post.
NOTE
- Only Ergotron-specified batteries may be used in the StyleView Power System. Contact Ergotron customer care for more details.
- Do not dispose of the Lithium battery in the trash. Recycle the battery according to local regulations.
Please note, the EPA classifies spent lithium batteries as "Universal Waste". The shipping requirements for "Universal Waste" are available at the EPA website at www.epa.gov.
Compatible Batteries:
- Lithium Werks U1-12RJ 1008896
- Inventus U1-45 07-56179-401
- Inventus U1-40 07-56178-001
- Inventus U1-45 07-56179-501
- ACE YL20015
- Inventus U1-40 07-56178-101
- Inventus U1-45 07-56179-101
Installing batteries other than the battery listed above will void the product warranty and result in power system malfunction. Failure to heed this warning may result in severe damage to batteries, power module and possible fire hazard.
Battery Replacement Instructions
For SV42 Carts
a. Turn off all mounted equipment.
b. Disconnect Power System from power source.
c. Turn power system off by holding down the AC Outlet Power button for 1 - 3 seconds. Power light will shut off.
a. Access the battery compartment.
b. Remove the battery cover.
c. Disconnect the battery cables.
a. Loosen the battery hold-down mechanism.
b. Disconnect cables: Battery Harness and Battery "Yellow" Comm 3.
c. Remove the old battery.
Caution: Do NOT swap battery cables, doing so will cause sparking and trip the circuit breaker.
a. Remove the Black (-) cable from the battery post.
b. Remove the Red (+) cable from the battery post.
c. Recycle the battery according to local regulations.
a. Install the new battery.
b. Connect the Red (+) cable to the battery post.
c. Connect the Black (-) cable to the battery post.
Caution: Connect Red (+) before connecting Black (-).
Torque Terminal Bolts to 110 in-lbs (with cables) or 25-30 in-lbs (without cables).
PLUG BATTERY HARNESS IN FIRST!
a. Connect the Battery Harness.
b. Connect the Battery "Yellow" Comm 3.
a. Replace the battery cover.
b. Secure the battery hold-down mechanism.
c. Reconnect the battery cables.
Follow Battery Charge/Discharge Initial Power on steps a, b, c.
For SV32 Carts
a. Turn off all mounted equipment.
b. Disconnect Power System from power source.
c. Turn power system off by holding down the AC Outlet Power button for 1 - 3 seconds. Power light will shut off.
a. Access the battery compartment.
b. Remove the battery cover.
c. Disconnect the battery cables.
a. Loosen the battery hold-down mechanism.
b. Disconnect cables: Battery Harness and Battery "Yellow" Comm 3.
c. Remove the old battery.
Caution: Remove Black (-) before removing Red (+).
a. Remove the Black (-) cable from the battery post.
b. Remove the Red (+) cable from the battery post.
c. Recycle the battery according to local regulations.
a. Install the new battery.
b. Connect the Red (+) cable to the battery post.
c. Connect the Black (-) cable to the battery post.
Caution: Connect Red (+) before connecting Black (-).
Torque Terminal Bolts to 110 in-lbs (Green with cables) or 25-30 in-lbs (Orange with no cables).
PLUG BATTERY HARNESS IN FIRST!
a. Connect the Battery Harness.
b. Connect the Battery "Yellow" Comm 3.
a. Replace the battery cover.
b. Secure the battery hold-down mechanism.
c. Reconnect the battery cables.
Follow Battery Charge/Discharge Initial Power on steps.
Battery Charge/Discharge
Initial Power on/Charge Battery (takes approximately 2.5 hours to charge)
Plug Cart's Power Cord into wall outlet.
Do Not stretch coiled cord further than 8 feet (2.5 meters), damage to the cord may occur.
Turn on power system by holding power button down for 1 - 3 seconds.
● Battery has 100% charge.
● Battery has less than 90% charge.
● Battery has less than 60% charge.
● Battery has less than 10% charge and alarm beeps. Light is orange and then turns red when battery has less than 5% charge. Plug-in power cord and charge to 100%! You can use cart while charging.
● Alarm Mute button. Pressing this will temporarily mute alarm. When battery has less than 5% charge, the alarm mute is only effective for 1 min.
● Power button for internal power system outlets. Pressing this will provide or remove power to/from components plugged into the internal outlets.
With cart's power cord plugged into the wall outlet, wait until cart is at 100% charge. (takes approximately up to 2.5 hours to charge)
LiFe ● 100
LiFe ● <90
LiFe ● <60
LiFe ● <10
If the battery is stored too long without recharging, the electronics in the battery may cause the battery voltage to drop below 10.8V. If this happens, the power system will enter a low charge recovery mode when plugged into power source.
During the low charge recovery process this light will be green. This light will be blinking red. Once the process has finished the power system will resume charging as normal. If the low charge recovery process takes longer than 45 min please contact Ergotron Customer Care.
When lit, alarm is enabled and will beep when battery charge gets below 10%. For details on enabling and disabling alarm contact Ergotron Customer Care.
When lit, the power system is on. When dark, power system is off.
This power system interface will alert you to the percentage of charge remaining in the cart battery with a series of steady or flashing red, yellow or green lights, and an alarm that will beep when charge gets below 10%. Remember, the battery needs to be charged to 100% every day, and you can use the cart while charging, so plug-in cord as often as possible to avoid running out of power!
NOTE: Put monitor in power save mode to optimize battery run time.
Light flashes when charging (power cord plugged into wall outlet). Allow battery to continue charging until light stops flashing. After light stops flashing, it is OK to unplug the power cord from the wall. You can use cart while charging.
If other lights are flashing red/green it could indicate a power system fault. If this occurs contact Ergotron Customer Care.
NOTE: Frequent operation of the cart while battery charge levels are below 10% will significantly reduce the life of your battery.
