Super Bright LEDs WP6 Series LED Wall Pack User Manual

Product Overview

This document provides the user manual for the Super Bright LEDs WP6 Series LED Wall Pack.

The WP6 Series LED Wall Pack is designed for outdoor lighting applications, offering efficient illumination and various features for customization.

Specifications

Check the product label for specific electrical specifications related to installation. Improper installation will void the warranty.

Wiring Diagram

120-277 VAC Input:

• Line: Connect to Black wire
• Neutral: Connect to White wire
• Ground: Connect to Green wire

0-10 V Dimming:

• Dim (+): Connect to Purple wire
• Dim (-): Connect to Gray/Pink wire

[Diagram Description: A schematic shows standard AC input connections with Line to Black, Neutral to White, and Ground to Green. A separate section illustrates 0-10V dimming connections with Dim (+) to Purple and Dim (-) to Gray/Pink.]

CCT and Wattage Selection

The fixture features selection switches for Color Correlated Temperature (CCT) and wattage, as well as a control for full light or dimming.

Selection Switch and Down / Full Light Control

This switch typically controls the primary light output, allowing selection between full brightness or a dimmed state.

Selection Switch for Wattage and Photocell

This switch allows adjustment of the fixture's wattage and enables or disables the photocell functionality.

Wattage Settings:

• XW: 40W
• YW: 32W
• ZW: 24W

Photocell Settings:

Switches labeled ON/OFF and PC are present for photocell control.

[Diagram Description: Two circular diagrams illustrate the selection switches. One shows a switch with positions labeled 'FULL' and 'DOWN'. The other shows multiple switches with labels like 'XW', 'YW', 'ZW', 'ON', 'OFF', 'PC'. Associated text indicates wattage values for XW, YW, ZW and photocell operation based on ambient light levels.]

Safety and Notes

• Product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
• Avoid looking directly into the lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
• The photocell sensor can be disabled by unplugging it and capping the connector that was attached to the sensor.

Installation Instructions

Wall/Junction Box Installation

1. Turn off power at the circuit.
2. Loosen two hex screws on the fixture. Remove the mounting bracket.
3. Screw the mounting bracket to the junction box to secure it.
4. Attach the safety cable. With supply power off, make all wiring connections.
5. Mount the LED fixture housing to the bracket.
6. Tighten the two hex screws to secure the LED fixture to the bracket.
7. Apply supply power at the circuit.

[Diagram Description: A sequence of illustrations shows the steps for wall/junction box installation: removing the fixture from the bracket, attaching the bracket to a junction box, making wire connections, and mounting the fixture onto the bracket.]

Flush Mount Installation

1. Turn off power at the circuit.
2. Loosen two hex screws on the fixture. Remove the mounting bracket.
3. Screw the mounting bracket to a flush surface to secure it.
4. Attach the safety cable. With supply power off, make all wiring connections.
5. Mount the LED fixture housing to the bracket.
6. Tighten the two hex screws to secure the LED fixture to the bracket.
7. Apply supply power at the circuit.

[Diagram Description: A sequence of illustrations shows the steps for flush mount installation, similar to the junction box method but indicating mounting to a flat surface. It includes attaching the bracket, making wire connections, and mounting the fixture.]