RGB LED Strip Lights
Remote Control
The remote control offers various functions for the LED strip lights:
- 1. Power On and Off
- 2. Quick/Slow Flash Setting
- 3. Brightness adjustment (25%, 50%, 75%, Full)
- 4. Automated or Flash Setting
- 5. 4 Sound-Syncing Modes
- 6. Fade Effects (3-Color Fade or 7-Color Fade)
- 7. Timer Settings (1 hour, 2 hours, 3 hours, 4 hours)
- 8. Jump Light Effects (3-Color Jump, 7-Color Jump)
- 9. RGBW color settings with 16 additional color selections
- 10. Adjust the color saturation
Remote Control Battery
The remote control comes with a 3V battery installed. To replace the battery, use a CR2025 3V battery. The battery compartment is located on the narrow side of the remote.
IMPORTANT: Be sure to line up the arrows on both ends of the 4-pin connector (male to female); otherwise, the lights will not work.
The system includes an IR & Sound Sync Box and a Power Adapter.
Installation
- Be sure to clean the surface you intend to install the strip lights on.
- Peel off the adhesive backing, making sure to not remove the actual adhesive.
- Press and firmly hold the light strip in place for 30 seconds.
- Connect strip lights to the IR controller and connect the receiver to a power source.
- Remove the tab from the battery compartment of the remote control.
Notes: Not all surfaces have the same textures, and some surfaces may require additional support to hold up the strip lights.
Technical Support
For assistance, email support@merkuryinnovations.com.
If you are experiencing problems, do not attempt to fix the product yourself or return it to the store you purchased it from. Please refer to the user manual or contact Merkury Innovations tech support.
