UTV Stereo UTVS-BCM Single Bank Battery Charger

Designed For UTV - Powersports - Marine

Contact: 480.616.2299 | www.utvstereo.com

This manual provides essential information for the UTV Stereo Single Bank Battery Charger.

Contents:

• Product Features
• Warnings/Precautions
• Operation Instructions
• Charger Specifications

Warranty Information

For service, consult the dealer where the product was purchased or a local UTV Stereo dealer. Units returned without an authorization number will not be processed. A copy of the purchase receipt from an authorized UTV Stereo dealer is required for in-warranty service. Units without a receipt will be held for 30 days. Visit the UTV Stereo website for more information.

Important Warnings:

• DO NOT SUBMERGE THIS PRODUCT. THIS WILL VOID YOUR WARRANTY.
• FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS COULD VOID YOUR WARRANTY.

UTV STEREO and the UTV STEREO logo are registered trademarks. Other brand names are trademarks of their respective owners.

Designed in USA. Copyright © 2025 UTV STEREO.

Contact: Tel. 480-616-2299 | Address: 7561 East Baseline Road Mesa, AZ 85209

Product Features

• Automatic charging and maintaining
• Overcharge protection
• LED indicator
• Short circuit protection
• Quick disconnect leads

Precautions:

WARNING - SHOCK HAZARD

• Do not operate with a damaged cord or plug.
• Do not disassemble; incorrect reassembly may result in electric shock or fire.
• NEVER submerge in water. Do not expose to rain, snow, or use when wet.
• Disconnect from power source before maintenance to reduce the risk of electric shock.

WARNING - RISK OF EXPLOSIVE GASES:

• The charger can produce arcs or sparks. Use only in well-ventilated areas.
• Take precautions when using near a lead-acid battery that generates explosive gases during normal operation.
• Follow these instructions and the battery manufacturer's instructions to reduce the risk of battery explosion or damage.

WARNING - RISK OF INJURY OR PROPERTY DAMAGE:

• Never attempt to charge a frozen battery.
• When disconnecting power, pull from the plug, not the cord.
• Never allow sparks or flames near the charger, battery, or vehicle engine.
• Remove personal items like rings or necklaces that could create a short circuit.
• Use protective eyewear and gloves to reduce exposure to battery acid.
• If battery acid contacts skin, wash with soap and water immediately.
• If battery acid contacts eyes, flush immediately with water.
• Seek medical attention if redness, pain, or irritation occurs from battery acid.

Operating Instructions

1. Connect the terminal rings/clamps to the corresponding terminals on the battery posts. Position the RED terminal on the POSITIVE (+) post connector and the BLACK terminal on the NEGATIVE (-) post connector.
2. Connect the AC power cord to an AC power outlet. Confirm the LED indicator is on.
3. Connect the 2-pin plugs to begin charging. This will start the charging process. Refer to the LED indicator for charging status.
4. LED Status Indicator:
   • Neither Red or Green light is on: Charger is not properly connected to AC power. Check outlet and connection.
   • Red light flashing: Battery charger has AC power and is functioning correctly.
   • Continuous red light flashing: Battery voltage is too low, or output terminals are not connected correctly.
   • Red light on constant: Battery is connected properly, and the charger is charging the battery.
   • Green light flashing: The battery is greater than 80% charged.
   • Green light on constant: The charge is complete, and the battery is fully charged.

Technical Data: