Introduction
Congratulations on your purchase of Enbrighten Café Lights. These lights are designed for long-lasting illumination with no bulbs to replace. You can connect additional lights to form a continuous string up to 750 feet.
IMPORTANT: Before installation, please read all warning statements included at the bottom of these instructions.
Step 1: Initial Setup
- Carefully unpack the Café Lights. Remove any wire ties.
- When installing outdoors, use a Ground Fault Circuit Interrupter (GFCI) receptacle. Plug the lights into the GFCI receptacle to ensure they work properly before mounting. IMPORTANT: Unplug the Café Lights prior to mounting.
Step 2: Installing Café Lights
- IMPORTANT: Mount Café Lights only to solid support structures like joists, beams, studs, or other solid mounting surfaces.
- Each Café Light is designed with universal keyholes for mounting with lights hanging downward. Mounting hardware (screws, nails, zip ties, hooks, etc.) is not included.
- Use the keyhole ear tabs or keyholes to mount the power supply.
- Guide wires, in compliance with local electrical and building codes, may also be used to support the Café Lights.
- Once the GFCI outlet location, mounting surface, and hardware are determined, mount your Café Lights.
- When finished mounting, place the female receptacle cover firmly over any unused outlet and plug the male plug into the GFCI Receptacle.
- Locate the remote control. Remove the back cover and insert two AAA batteries (included). Replace the back cover securely.
- To power on your Café Lights, press the red ON/OFF button on the top of the remote. NOTE: Keep the remote indoors when not in use.
- Explore the following programmable settings via your remote:
- Single Color Selection: Choose any color by pressing the corresponding button on the color pad to set all lights to that color. You can also press the dimming button to select one of 10 light levels. Dimming is available for single- and dual-color selection.
- Dual Color Selection: Press "Color 1" and select a color from the pad to set odd-numbered bulbs (starting with the first). Press "Color 2" and select a color to set even-numbered bulbs (starting with the second). During selection, press the dimming button for 10 light levels.
- Strobe Selection: Press the "Strobe" button to cycle through all colors in a random strobe pattern.
- Fade Selection: Press the "Fade" button to fade lights in and out through all colors in a random pattern.
- Modes Selection: Press the "Modes" button repeatedly to cycle through preset modes: Twinkle, Red/White/Blue, Multi Fade, Fall, Christmas, Spring, St. Patrick's Day, Multi.
- Timer Selection: Press the "2 Hour Timer" button to set a two-hour countdown until lights turn off. Press the "4 Hour Timer" button for a four-hour countdown.
- To power off your lights, press the red ON/OFF button on the remote. NOTE: Your Café Lights will remember the last customized settings and turn back on in the same mode/color scheme.
Step 3: Installing Multiple Café Light Sets
Extend your lighting by connecting more than one strand together to form a continuous string up to 750 feet. Follow the installation steps above, ensuring each connection is secure and the end female receptacle is covered.
Available Lengths:
| Length (feet) | Bulbs | Model Number |
|---|---|---|
| 24 | 12 | 37791 |
| 36 | 18 | 36632 |
| 48 | 24 | 37790 |
See below for electrical rating information.
Step 4: Removing Café Lights
- Always unplug Café Lights from their receptacle before removing.
- Carefully remove each light individually from the mounting hardware. NOTE: For safety, never pull or jerk lights from the mounting hardware.
- Store lights in a dry location.
SAVE THESE INSTRUCTIONS
Enhance Your Lighting
Simplify your Café Light experience by automating on/off times and adding decorative shades for a personalized style.
Recommended Accessories:
- myTouchSmart Outdoor Timer (Plug-in) Model #26898: The easiest timer to set; simply select your time and go.
- myTouchSmart Timer (In-Wall) Model #26893: Provides easy-set controls if your receptacle is controlled by a switch.
- GE Bluetooth Outdoor Smart Switch (Plug-in) Model #13868: Wirelessly schedule and control outdoor lights or other devices from your smartphone or tablet.
- GE Bluetooth Smart Switch (In-Wall) Model #13869: Offers the same Bluetooth control if your receptacle is controlled by a switch.
- Enbrighten Café Lens Shade (Stainless Steel) Model #35917: Express your unique style with a variety of shapes and finishes.
- Enbrighten Café Lens Shade (Oil-Rubbed Bronze) Model #35877: Express your unique style with a variety of shapes and finishes.
Important Information & Warnings
Refer to the manual or visit www.byjasco.com for warranty limitations, restrictions, and product registration information.
WARNING: Outdoor Use Precautions
- When using outdoors, always follow basic safety precautions to reduce the risk of fire, electric shock, and personal injury.
- Use a Ground Fault Circuit Interrupter (GFCI) protected circuit or outlet for wet locations.
- Use only with outdoor-rated extension cords (e.g., SEW, SEOW, SEOOW, SOW, SOOW, STW, STOW, STOOW, SJEW, SJEOW, SJEOOW, SJW, SJOW, SJOOW, SJTW, SJTOW, or SJTOOW).
WARNING: Packaging
- Keep plastic bags away from babies and children. Do not use in cribs, beds, carriages, or playpens, as the thin film may cling to the nose and mouth and prevent breathing.
NOTE:
- Ensure the Café Light's receptacle cover is firmly installed and well seated when not connecting additional strings.
Warranty Information
This Jasco product is warrantied for three (3) years with a limited-lifetime replacement warranty on the Enbrighten LED light source only. Visit www.byjasco.com for full warranty details.
Distributed by Jasco Products Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114.
Questions? Contact Jasco Products at 1-800-654-8483 between 7:00 AM - 8:00 PM CST.
Patents pending | www.cafelights.com
Electrical Ratings
| Input | Input Watt, Max. | Location Use | Model No. |
|---|---|---|---|
| 120 V, 50/60 Hz | 6W | Wet | RGB /*/6/*/* |
| 120 V, 50/60 Hz | 9W | Wet | RGB /*/9/*/* |
| 120 V, 50/60 Hz | 12W | Wet | RGB /*/12/*/* |
| 120 V, 50/60 Hz | 17W | Wet | RGB /*/18/*/* |
| 120 V, 50/60 Hz | 23W | Wet | RGB /*/24/*/* |
| 120 V, 50/60 Hz | 3W | Wet | RGB /*/3/*/* |
| 120 V, 50/60 Hz | 4W | Wet | RGB /*/4/*/* |
| 120 V, 50/60 Hz | 8W | Wet | RGB /*/8/*/* |
| 120 V, 50/60 Hz | 15W | Wet | RGB /*/16/*/* |
CAUTION
- BATTERIES MAY LEAK HARMFUL LIQUIDS OR IGNITABLE MATERIALS OR EXPLODE CAUSING INJURY AND PRODUCT DAMAGE.
- DO NOT MIX OLD AND NEW OR OTHER BATTERY TYPES.
- REPLACE ALL BATTERIES AT THE SAME TIME.
- REPLACE EXHAUSTED BATTERIES IMMEDIATELY.
- REMOVE BATTERIES IF PRODUCT IS TO BE UNUSED FOR EXTENDED PERIODS OF TIME.
Requires 2 AAA batteries. Observe polarity markings (+), (-).
WARNING
RISK OF ELECTRIC SHOCK
- Receptacle outlets used for powering Café Lights shall comply with all national and local electrical codes. Consult a local electrician if unsure.
- For use only on GFCI protected circuits.
- DO NOT SUBMERSE.
- DO NOT USE AROUND AQUARIUMS.
- Café Lights are a wet location product and have no serviceable parts.
- DO NOT USE WITH EXTENSION CORD NEAR WATER OR WHERE WATER MAY ACCUMULATE.
- KEEP LAMPS AT LEAST 16 FEET FROM POOLS AND SPAS.
- KEEP PLUGS AND RECEPTACLES DRY.
- AVOID DAMAGE TO CORDS AND LAMP ASSEMBLIES DURING INSTALLATION. Periodically inspect for physical damage or damage caused by outdoor exposure.
- REPLACE ANY DAMAGED CAFÉ LIGHT STRINGS.
- DO NOT INSTALL IN LOCATIONS WHERE CAFÉ LIGHTS CAN BE STEPPED ON.
- ENSURE CAFÉ LIGHTS ARE UNPLUGGED FROM POWER DURING INSTALLATION.
- Café Lights should be installed out of the reach of children.
- UL recommends testing GFCI circuits and receptacles monthly.
- DO NOT OPERATE WITHOUT BULB SECURELY SCREWED IN.
RISK OF FIRE
- Café Lights are designed to be mounted using their individual keyhole mounting feature. Do not mount by using the main electrical cord or individual drop cords.
- Café Lights are designed to be linked to a maximum distance of 350 feet using their electrical plugs and receptacles.
- Café Light interconnecting receptacles are intended only for linking compatible Café Light strings. Do not use for any other electrical purpose.
- DO NOT MOUNT CAFÉ LIGHTS IN ANY POSITION WHERE THE BULB IS FACING UP.
- DO NOT ALLOW LED LAMP ASSEMBLIES TO CONTACT COMBUSTIBLE MATERIALS. LED LAMP ASSEMBLIES SHOULD HANG FREELY AND NOT BE SUSCEPTIBLE TO REPETITIVE DAMAGE FROM ENVIRONMENTAL CONDITIONS.
- NOT INTENDED FOR INSTALLATION IN CEILINGS, SOFFITS, CABINETS, ATTICS, OR OTHER ENCLOSED SPACES.
FCC Compliance
This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If this equipment causes harmful interference to radio or television reception, try to correct it by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
