THY13VK HYUNDAI i30 SW / KIA C’eed SW 2012>
Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | Crossmember | D | 2 | M12 x 25 Bolts & S/P Washers |
| B | 2 | Handed Side arms | E | 6 | M10 x 40 x 1.25 Bolts & S/P Washers |
| C | 1 | Detachable 6201 | F | 4 | M12 x 40 Bolts, Nuts & S/P Washers |
| G | 2 | M12 x 22 Bolts & S/P Washers | |||
| H | 8 | 12 x 25 Flat Washers | |||
| J | 1 | Flip Up Socket Plate TTFP/LH | |||
| K | 6 | 10 X 25 Flat Washers |
TOWBAR INSTALLATION
- Remove the rear under tray.
- Remove the Towing eye from the N/S chassis member. (This is not refitted with the Towbar assembly but gets handed back to the customer and refitted if ever the Towbar is removed).
- Using Item E with Item K fit Items B to each chassis member.
- Cut the rear bumper lower edge as shown in sketch below.
- Using Item F with Item H fit item A to Items B.
- Using Items G with Items H and Items D with Items H fit Item C and Item J to Item A.
- Fully tighten all fixings ensuring Towbar is rigid, square and secure.
- The N/S under tray can either be cut around Item B so a flush fitting is achieved back to the vehicle or handed back to the customer and refitted if ever the Towbar is removed.
Diagram Description
The diagram illustrates the Tow-Trust THY13VK towbar assembly for the Hyundai i30 SW / Kia C'eed SW (2012 onwards). It shows the main crossmember (Item A), which is the central horizontal bar of the towbar. This crossmember connects to the vehicle's chassis via two handed side arms (Item B), one for each side. The detachable towball unit (Item C) is shown mounted to the crossmember, featuring a mechanism for attaching and detaching the towball. The diagram also depicts the various fasteners required for installation: M12 x 25 bolts and S/P washers (Item D), M10 x 40 x 1.25 bolts and S/P washers (Item E), M12 x 40 bolts, nuts, and S/P washers (Item F), M12 x 22 bolts and S/P washers (Item G), and 12 x 25 flat washers (Item H). Additionally, a flip-up socket plate (Item J) and 10 x 25 flat washers (Item K) are shown. The diagram uses letter labels (A, B, C, D, E, F, G, H, J, K) to correspond with the parts list. A crucial part of the diagram shows the vehicle's rear bumper area with a 'BUMPER CUT' indicated. This cut-out has specific dimensions: 215mm and 45mm, detailing the area of the bumper that needs to be trimmed to ensure a flush and correct fit for the towbar assembly.
Notes
- Recommended Torque Setting for M12 Grade 10.9 is 139 Nm. (For other Torque Settings, please refer to overleaf notes.)
- Nose load limits and vehicle manufacturers' trailer/caravan weight limits must be observed.
