VIVIDBAR2 24x 4W RGBW LED Lighting Bar

This user manual provides essential information for the safe and effective operation of the VIVIDBAR2 LED Lighting Bar. Please read this manual carefully before initial use.

Event Lighting reserves the right to revise the manual at any time. Information and specifications within this manual are subject to change without notice. Event Lighting assumes no liability or responsibility for any errors or omissions. Please consult Event Lighting for any clarification or information regarding this item. Version: 1

Website: www.event-lighting.com.au

Safety Instructions

Warning

• Do not open this fixture; there are no user-serviceable parts inside. Risk of electric shock.
• Do not look directly at the light source when the fixture is on.

Caution: This unit's housing may become hot during and after operation.

• Install this fixture in a location with adequate ventilation, at least 50 cm from adjacent surfaces.
• Do not leave any flammable material within 50 cm of this unit while operating or connected to power.
• Use a safety chain when mounting this fixture overhead.
• Do not operate this device in any location where excessive dust, heat, water, or humidity may affect it.
• Do not operate this fixture if the housing, lenses, or cables appear damaged.
• Do not connect this fixture to a dimmer or rheostat.
• ONLY connect this fixture to a grounded and protected circuit.
• ONLY use the hanging bracket to carry this fixture.
• In case of a serious operating problem, stop using immediately.
• The maximum ambient temperature is 40° C. Do not operate this fixture at higher temperatures.

Power Input

This fixture has an auto-switching power supply that works with an input voltage range of 110-240V AC, 50/60 Hz.

Product Installation

• Attach the four parcans to the four mounting points on the controller bar.
• Connect the four parcans to the four cables on the controller bar.
• Insert the controller bar into the stand and tighten the screw to secure.
• Extend the tripod and place it on a stable surface.

Menu

The fixture features a menu system controlled by buttons A (MENU), B (UP), C (DOWN), and D (ENTER). The display shows "8.8.8.8." during operation.

Menu Options

DMX Chart

This fixture is controlled by the universal DMX 512 protocol. The DMX address is the first channel used to receive instructions from the external controller. For independent control, each fixture must be assigned a unique address for each of its control channels. For example, this device has one channel modes: 8, if it's set to 8 channel mode, and there are several fixtures need to be independently controlled, we just simply address first fixture at 1, and second fixture at 9, third one at 17, etc.

• If multiple fixtures have the same DMX address, they will behave synchronically.
• Display will flash when no DMX signal is received.

IR Remote

The fixture can be controlled via an IR remote. Key functions include:

• A1: Effect 1 – all lights on
• Power button: [power-symbol]
• A2: Effect 2 – colour jump
• A3: Effect 3 – colour fade
• A4: Sound active mode
• A5: Strobe mode
• Colour buttons: Colour adjustment
• Speed buttons: Speed adjustment
• DMX buttons: DMX channel selection
• IP buttons: running effect

Technical Specifications

• Light Source: 24x 4W RGBW LEDs
• Beam angle: 25°
• Dimming: 0-100%
• Operation Modes: DMX, auto, manual, sound active, IR remote
• Control Interface: 3-pin XLR in/out, IR remote
• DMX Channels: 8
• Input Voltage: 110-240V AC, 50/60 Hz
• Power Consumption: 100W

Warranty

Please contact your local dealer or Event Lighting for warranty information.