SwanScout Multifunctional Wireless Charging Station
Scout for elegance
Product Overview
Before using this product, please read this user manual thoroughly and take good care of it.
The device is a wireless charging station with a clock display. It features distinct charging areas for a phone, a smartwatch, and an earbud charging case. Key components are labeled: 1. Wireless charging area for phone, 2. Clock display screen, 3. Brightness touch adjustment, 4. Phone charging indicator, 5. Watch charging indicator, 6. Earbuds charging case charging indicator, 7. Wireless charging area for watch, 8. USB-C interface, 9. Wireless charging area for earbuds charging case, 10. Time setting "-" button, 11. Time setting "+" button, 12. Time setting button, 13. Wireless charging switch button for phone.
Product Instructions
Illustration shows a power cable connecting to the USB-C port of the charging station and the other end to a charging adapter.
- Connect one end of the power cable to the USB-C port of the product and the other end to the charging adapter.
- Adjust wireless charging pads for phone and watch to appropriate positions as shown in the illustration on the right before use.
- Place your phone, watch, and earbud charging case on the corresponding wireless charging areas to charge.
- Single press the "Wireless charging switch button for phone" to turn off the wireless charging function for your phone, without interrupting the charging of other devices. To restart wireless charging for phone, press the button again.
Note: It may not be feasible to charge all three devices (phone, earbud charging case, and watch) simultaneously if you don't use a charger higher than 18W power.
Time Setting
Press the "Time Setting" button to select the 12/24 hour system.
To set the hour: Press and hold the "Time Setting" button for 3 seconds to enter setting mode, then adjust the hour using the "+/-" button.
To set the minutes: Press and hold the "Time Setting" button for 3 seconds, then briefly press the "Time Setting" button again to enter setting mode, and adjust the minutes using the "+/-" button.
Note:
- After setting, wait for 5 seconds to complete the setting.
- The clock display will run fast or slow due to high or low ambient temperature; please adjust the clock in time.
Display Screen Adjustment
Click the brightness touch adjustment icon to adjust the screen brightness. The screen brightness can be adjusted in four levels that cycle through sequentially.
| Level | Level 1 | Level 2 | Level 3 | Level 4 |
|---|---|---|---|---|
| Display brightness | Low | Medium | High | OFF |
Product Compatibility
Please refer to the website's images or text descriptions for information on specific compatible types of phones, earbuds charging cases, and watches.
Attention
1. This clock is powered by a lithium battery. If it is not powered for a long time, the battery may be depleted and enter sleep mode. It is recommended to power it every 15 days and charge the battery for at least 30 minutes each time to ensure normal use of the clock and extend the battery's lifespan.
2. When the battery is completely depleted, the clock will restore factory settings and you will need to reset the time.
3. This product has an intelligent energy-saving function. It will automatically turn off the time display within 10 minutes when not connected to the power supply.
Indicator Light Guide
| Charging status | Indicator light | Plugged in | Standby | Charging | Fully charged | Abnormal objects detected |
|---|---|---|---|---|---|---|
| Indicator light | On for 3 Sec | OFF | Green light | Green light | Red light flashes |
Charging Distance and Folding Angle
- Do not fold the wireless charging pad at an angle over 90 degrees to avoid damage.
- To ensure that the charging station works properly, the phone case should not exceed 5 mm, the earbud case should not exceed 4 mm, and the watch should be closely attached to the charging area.
- Check and adjust the device's position in the appropriate charging area if it cannot charge properly.
Warning
- Do not disassemble or change the internal structure of this product by yourself to avoid danger.
- Please use this product in the temperature range of 0°C -40°C (32°F -104°F). Do not use this product in high temperature and humid places to avoid equipment failure.
- Do not place metallic foreign objects in the wireless charging area.
- Do not throw this product into the fire, otherwise may cause the equipment to catch fire or explode.
- This product contains sensitive electronic components, including a battery, and can be damaged, impair functionality, or cause injury if dropped, burned, punctured, crushed.
- Do not expose this product to high temperature or around heat generating devices such as heaters, microwave ovens, ovens, etc.
- Do not allow children or pets to swallow this product to avoid injury or other hazards.
- Radio waves generated by this product may interfere with pacemakers, defibrillators, or other medical devices. Maintain a safe distance of separation between your medical device and this product. Consult your physician and medical device manufacturer for information specific to your medical device. Stop using this product if you suspect it is interfering with your pacemaker, defibrillator, or any other medical device.
- Please comply with local regulations for the disposal of this product and its accessories, and support recycling operations.
Specifications
Input: 5V/3A, 9V/2A, 12V/1.5A
Charging phone output: 12W (Max)
Charging watch output: 2.5W (Max)
Charging earbuds output: 3.5W (Max)
