99-3105 Installation Instructions

Installation Steps

1. Step 1: Prepare Vehicle

   Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) pop-clips from the sides of the radio trim bezel. Unclip the radio trim bezel, disconnect the switch wiring, and remove the bezel. Remove (2) 7mm hex-head screws securing the top of the factory head unit and disconnect the wiring.

2. Step 2: Mount Radio Housing

   Mount the Radio Housing to the sub-dash with (2) 7mm hex-head screws previously removed in step #1.

3. Step 3: Secure Housing Tabs

   Reach through the Radio Housing and mount the lower Housing tabs to the sub-dash with (2) Captive Studs and (2) Pal Nuts supplied.

4. Step 4: Wiring Connections

   Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. Isolate and individually tape off the ends of any unused wires to prevent electrical short circuits.

   Wire Preparation:

   • A) Strip wire ends back 1/2"
   • B) Twist ends together
   • C) Solder
   • D) Tape

5. Step 5: Install Head Unit

   Slide the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. Re-connect the battery terminal and test the unit for proper operation.