Demarest 6319 Wall Sconce
Safety Warnings and Cautions
- ⚠️ Electrical Safety: Disconnect power before re-lamping or wiring. Read all instructions completely before starting installation. To avoid the risk of fire or shock, the fixture must be installed in compliance with all applicable national and local electrical/building codes. Installation and maintenance should be completed by a licensed electrician or certified factory-trained technician.
- ⚠️ California Proposition 65: This lighting fixture contains chemicals known to the state of California to cause cancer, birth defects, and/or other reproductive harm. Wash hands after use.
- Unpacking and Inspection: Unpack the fixture, parts, and parts bag(s) before discarding the carton. Make certain that all parts are found. Inspect the fixture prior to installation for any damage. Hudson Valley Lighting Group (HVLG) does not pay or reimburse electrician fees. Fixtures may not be returned once installed. See warranty for exceptions.
- Cleaning: Please clean with a soft, dry cloth only! Do not use cleansers.
Diagram Description
The diagram illustrates the assembly of the Demarest 6319 wall sconce. It shows: 1. A junction box mounted to a wall structure. 2. The mounting plate (A) being attached to the junction box with mounting screws (B). 3. The ground wire being connected to the ground screw (C) on the mounting plate or the ground wire in the outlet box. 4. The white fixture lead being connected to the neutral wire in the outlet box using a wire nut (D). 5. The black fixture leads being connected to the hot wire in the junction box, also secured with a wire nut. 6. The fixture assembly (F) being attached to the mounting plate (A) and secured with fixture mounting screws (E). 7. A bulb (G) being screwed into the fixture's socket. 8. The shade (H) being placed over the bulb.
Parts List
| PART(S) | REPLACEMENT PART NAME | NUMBER |
|---|---|---|
| A,B,C,D | HARDWARE KIT | HDW-02 |
| E | FIXTURE MOUNTING SCREW | SCR-M |
| H | SHADE | SHD-6319 |
Installation Instructions
- Attach the MOUNTING PLATE (A) onto the junction box using the MOUNTING SCREWS (B). This fixture is designed to be mounted on a standard round or octagon junction box. The junction box must be securely mounted to the structure of the building.
- Attach the Ground wire (Green) to the ground inside the outlet box (Generally green or bar copper wire) or the GROUND SCREW (C) on the MOUNTING PLATE (A). NEVER CONNECT GROUND WIRE TO "HOT" WIRE! FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
- Connect the white fixture lead to the neutral (Generally white) wire in the outlet box. Fasten the wires together with an approved fastener (WIRE NUT) (D). Starting 1" below the fastener, tightly wrap the connection with electrical tape so that the connections seal the end of the fastener. MAKE SURE THERE ARE NO EXPOSED WIRE STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
- Connect the black fixture leads to the hot (Generally black) wire in the junction box. Fasten the joined wires the same as the previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
- Attach the FIXTURE ASSEMBLY (F) to the MOUNTING PLATE (A) and secure with the FIXTURE MOUNTING SCREWS (E).
- Screw the BULB (G) into the SOCKET of the fixture. THIS FIXTURE IS RATED FOR MAX 8 WATT TYPE B LAMP. DO NOT EXCEED THE RECOMMENDED WATTAGE!
- Place the SHADE (H) over the BULB (G) of the fixture.
- Restore power to the outlet at the breaker or fuse box.
Hudson Valley Lighting Group
