Hudson Valley Lighting Group

Important Safety Information

General Warnings

WARNING/CAUTION:

• Disconnect power before re-lamping or wiring the fixture. Read all instructions completely before starting installation.

• To avoid the risk of fire or shock, the fixture must be installed in compliance with all applicable national and local electrical/building codes. Installation and maintenance should be completed by a licensed electrician or certified factory-trained technician.

California Proposition 65 Warning

• This lighting fixture contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive harm. Wash hands after use.

Handling and Cleaning

• Unpack fixture, parts, and parts bags before discarding the carton. Ensure all parts are found. Inspect the fixture prior to installation for any damage. Hudson Valley Lighting Group (HVLG) does not pay or reimburse electrician fees. Fixtures may not be returned once installed. See warranty for exceptions.

• Please clean with a soft, dry cloth only! Do not use cleansers.

Installation Steps

Follow these steps carefully for proper installation of your Onteora 5316 fixture.

Diagram Description

The diagram illustrates the mounting plate, junction box, various screws, wire nuts, and the fixture assembly. Key components are labeled with letters A through J:

• A: Mounting Plate
• B: Mounting Screws
• C: Ground Screw
• D: Wire Nut
• E: Wall Anchor
• F: Wood Screw
• G: Fixture Mounting Screws
• H: Fixture Assembly
• I: Bulb (not included)
• J: Glass Assembly

1. Determine the location for the lamp. Using the mounting plate as a template, mark the location of the holes for the WALL ANCHOR (E).
2. Drill the appropriate size holes for the WALL ANCHOR (E). The holes should be slightly smaller than the size of the anchors. Install the wall anchors into the hole.
3. Attach the MOUNTING PLATE (A) onto the junction box using the MOUNTING SCREWS (B). This fixture is designed to be mounted on a standard junction box. The junction box must be securely mounted to the structure of the building. Screw in the WOOD SCREW (F) to the WALL ANCHOR (E).
4. Attach the Ground wire (Green) to the ground inside the outlet box (generally green or bare copper wire) or the GROUND SCREW (C) on the MOUNTING PLATE (A). NEVER CONNECT GROUND WIRE TO "HOT" WIRE! Failure to follow this could result in serious injury or death.
5. Connect the white fixture lead to the neutral (generally white) wire in the outlet box. Fasten the wires together with an approved fastener (WIRE NUT) (D). Starting 1" below the fastener, tightly wrap the connection with electrical tape so that the connections seal the end of the fastener. MAKE SURE THERE ARE NO EXPOSED WIRE STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
6. Connect the black fixture leads to the hot (generally black) wire in the junction box. Fasten the joined wires as in the previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. Failure to follow this could result in serious injury or death.
7. Attach the FIXTURE ASSEMBLY (H) to the MOUNTING PLATE (A) and secure with the FIXTURE MOUNTING SCREWS (G).
8. Screw the BULB (I) into the SOCKET of the fixture. THIS FIXTURE IS RATED FOR MAX 10 WATT LED TYPE T8-3.5 LAMP. DO NOT EXCEED THE RECOMMENDED WATTAGE!
9. Screw the GLASS ASSEMBLY (J) into the FIXTURE ASSEMBLY (F) of the fixture.
10. Restore power to the outlet at the breaker or fuse box.

Replacement Parts