Package Contents (Parts are not to scale)
| Part | Description | Quantity |
|---|---|---|
| A | Fixture body | 1 |
| B | SS Self-Tapping screw | 2 |
| C | Wall expansion particle | 2 |
| D | Plastic cylinder (H) 8mm | 2 |
| E | Fiber sleeve | 2 |
Parameters
| Rated Wattage | Rated Voltage | Color Temperature | Lumen | Lamp guarantee | IP Class | Dimension |
|---|---|---|---|---|---|---|
| 10W | 220-240V | 3000K | 830M | 3 years | IP20 | 250*250*50mm |
Care and Cleaning
Exterior Maintenance
- To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the surface of the fixture.
- Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
Installation Instructions
Pre-Installation
PLANNING THE INSTALLATION
Read all instructions before assembly and installation. Before starting installation of the fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.
Tools Required
- ? Phillips Screwdriver
- ? Flathead Screwdriver
- ? Knife
- ✂️ Wire Cutter
- ? Percussion drill
- Chopping bit Dia 6 mm
- ? Ladder
- ? Safety Goggles
Installation (Make sure to turn off the main power)
Step 1
The fixture base is shown being held against the ceiling, indicating the intended mounting location.
Step 2
The mounting base plate is being attached to the ceiling. Arrows indicate screw placement. A distance of 70mm is noted, likely for screw spacing. Electrical wires are visible.
Step 3
The main fixture body is being brought towards the mounted base plate. Electrical connections are being made, with labels for Live (L) and Neutral (N) wires.
Step 4
The fixture body is being secured to the base plate, likely by twisting or screwing it into place.
Installation (continued)
Step 1
The main light fixture body is presented, ready for attachment.
Step 2
The fixture is being aligned with the ceiling mount and connected to the electrical wires (L for Live, N for Neutral).
Step 3
Screws are being inserted to firmly secure the fixture to the ceiling mount.
Step 4
The final cover or diffuser is being attached to complete the installation.
