Nova Life Interior Pendant
Installation Manual
Article Nr. 54808-003-71
Website: www.lampehuset.no
Package Contents
Parts are not to scale.
An illustration shows various parts labeled A through G, including a fixture body with wire, wall expansion particle, self-tapping screws, screws, silicone gaskets, glass, and glass shade fixing bolts.
| Part | Description | Quantity |
|---|---|---|
| A | Fixture body with wire | 1 |
| B | Wall expansion particle | 4 |
| C | Self-Tapping screw | 4 |
| D | Screw | 3 |
| E | Silicone gaskets | 3 |
| F | Glass | 3 |
| G | Glass shade fixing bolt | 3 |
Light Source
Max 230V E27 3 x 40W (not included). Recommend LED bulb.
Care and Cleaning
Exterior Maintenance
- To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the surface of the fixture.
- Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
Pre-Installation
Planning the Installation
Read all instructions before assembly and installation. Before starting installation of the fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.
Tools Required
An illustration displays the necessary tools: Phillips screwdriver, flathead screwdriver, knife, wire cutter, percussion drill with a 6mm chopping bit, ladder, and safety goggles.
Installation
Caution
Warning: Only use bulbs as directed on the label on the lamp. Turn off the lamp before replacing the bulb and wait until the bulb has cooled. Take special care when touching the lamp when it is lit, as it can be hot.
Step 1
Shows attaching part 2 (likely a mounting bracket) to the ceiling, with wires being fed through.
Step 2
Illustrates connecting wires to the terminal box (labeled N and L), with the fixture wire and supply wire shown.
Step 3
Depicts mounting the fixture body (part 1) to the ceiling bracket, securing it with screws (part 3).
Step 4
Shows attaching the glass shades (part F) using the fixing bolts (part G).
Operation
- Turn on power at the circuit breaker or fuse box.
- Turn the light switch on to activate the fixture.
