Important Safety Information
⚠️ IMPORTANT: For indoor use only.
Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
Assembly Instructions
Step 1: Assemble Lamp Structure
The lamp has a central rod with three arms. Attach the lamp holders to the ends of these arms using the threaded rings and caps provided.
Step 2: Install Bulbs and Shades
Screw the light bulbs (not included) into the lamp holders. Then, screw the glass shades onto the lamp holders until they are securely fitted.
Step 3: Attach Ceiling Canopy to Lamp Body
Connect the ceiling canopy to the top of the lamp's central rod.
Step 4: Electrical Wiring
⚠️ IMPORTANT: Always shut off power to the circuit before starting installation.
Connect the mains electrical wires to the lamp wires using the provided junction box. Feed the mains cable through the junction box entry point. Strip approximately 20 mm (3/4") of insulation from the ends of the wires. Connect the live wire (L) to the 'L' terminal and the neutral wire (N) to the 'N' terminal within the junction box. Close the junction box cover until it clicks into place.
Step 5: Mount to Ceiling
Hang the assembled lamp from a ceiling hook. Ensure there is sufficient slack in the electrical wires (approximately 20-35 mm / 3/4" - 1 3/8"). Route the electrical wires neatly through the ceiling canopy. Mount the ceiling canopy to the ceiling by pushing it upwards and screwing it onto the mounting bracket. Finally, attach the main lamp body to the ceiling canopy by screwing it onto the threaded rod.
