Advanced Comfort Flush Keypad FRM703

Package Contents

• Advanced Comfort Flush Keypad (FRM703)
• Two #10 x 5/8" Wood Screws (labeled H14)

Note: The desk is often shown upside down during assembly and installation of the keypad. The keypad's position will be on the opposite side once the desk is flipped upright.

Step 1 - Attach Keypad to Desktop

UPLIFT desktops typically have pre-drilled attachment holes for the keypad. These holes are located on both the left and right sides, allowing you to choose your preferred mounting location.

If your desktop does not have pre-drilled holes, please refer to the Optional Desktop Drilling Instructions section below.

1. Align the keypad's mounting holes with the pre-drilled holes in the desktop.
2. Secure the keypad to the desktop using two #10 x 5/8" wood screws (labeled H14). Be careful not to overtighten the screws to prevent stripping the material, especially if using a power drill.

Step 2 - Perform Desk Reset Procedure

Important: Before using your desk, it is crucial to perform the Desk Reset procedure. This ensures the desk legs are properly calibrated after assembly.

1. Press and hold the DOWN button until the desk reaches its lowest height, then release the button.
2. Press and hold the DOWN button again for up to 15 seconds until the keypad display shows a reset indicator [e.g., '0' or 'rSt'], then release the button.
3. Press and hold the DOWN button again. The desk should lower slightly and then rise slightly. Release the button. If the desk does not move, repeat the reset procedure.
4. Your desk is now ready for use.

Optional Desktop Drilling Instructions

If you are using your own desktop or wish to attach the keypad in a location other than the pre-drilled holes:

• Position the keypad on the desktop and mark the center of each mounting hole with a pencil.
• Drill pilot holes using a 1/8" drill bit.
• Depth Control: To prevent damaging the desktop surface, drill no deeper than 1/2 inch. A recommended method is to wrap a piece of tape around your drill bit 1/2 inch from the tip and stop drilling just before the tape touches the desktop.

Step 3 - Keypad Settings & Programming

For detailed Settings and Programming instructions, please visit:

https://www.upliftdesk.com/desk-assembly-and-programming/

Safety and Warnings

Please refer to the Safety and Warnings section within the assembly instructions provided with your desk frame for comprehensive safety information.