Fanatec ClubSport Steering Wheel RS Quick Start Guide

A. Package Content

• 1x ClubSport Steering Wheel RS
• 1x ClubSport Magnetic Paddle Module
• 1x 2mm Allen Key
• 1x 4mm Allen Key
• 8x Screws

Note: Some items may be sold separately.

B. Quick Release Attachment

Follow these steps to attach the Quick Release:

1. Align the ClubSport Steering Wheel RS with the Quick Release shaft on your Fanatec Wheel Base.
2. Slide the wheel onto the shaft.
3. Secure the wheel using the provided screws and the 4mm Allen key. Tighten screws to a torque of 1 Nm. ⚙️

Diagram Description: Shows the process of attaching the quick release to the steering wheel shaft and securing it with screws.

C. Centre Calibration

Calibrate the steering wheel's center position:

1. Press the 'Tuning Button' to enter the Tuning Menu. ?
2. Navigate to and select the 'CAL' (Calibration) option.
3. Rotate the steering wheel fully to the left, then fully to the right.
4. Center the steering wheel and press the 'Tuning Button' again to confirm. ✔️

Diagram Description: Illustrates the steps for center calibration: entering the tuning menu, selecting calibration, rotating the wheel, and confirming the center position.

D. Shifter Calibration

Calibrate the sequential shifters:

1. Enter the Tuning Menu. ?
2. Navigate to and select the 'SEQ' (Sequential) option.
3. Perform the following for each gear: Press the clutch pedal, shift into the desired gear, and press the corresponding button on the wheel.

Diagram Description: Outlines the shifter calibration process, detailing how to set each gear by pressing the clutch, shifting, and pressing a specific button on the wheel.

E. Modes & F. Tuning Options

Modes:

• Repeat: Configures how button presses are registered. (Wheel Base Dependent)

Tuning Options:

• Enter Tuning Menu: Press the 'Tuning Button'. ?
• Navigate: Use the FunkySwitch™ or other directional inputs.
• Exit Tuning Menu: Press the 'Tuning Button' again. ❌

G. ClubSport Magnetic Paddle Module Adjustment

Adjust the position of the magnetic paddle modules:

1. Loosen the screws on the paddle module using the 2mm Allen key. ?
2. Slide the module to your preferred position.
3. Retighten the screws to secure the module.

Diagram Description: Depicts adjusting the magnetic paddle module by loosening screws, sliding the module, and retightening.

H. Button Mapping

Map buttons for PC and PlayStation. Specific assignments may vary by game and wheel base.

I. Support

For further assistance, visit:

• Fanatec App: fanatec.com/app
• Support & FAQ: fanatec.com/support/faq
• Video Manual: fanatec.com/QR/CS-RS