Buffalo Commercial Non-Stick Rice Cooker J300-A

Product Overview

Buffalo 1.95kW Commercial Non-Stick Rice Cooker, 6 Litre capacity. Features a rice capacity of 13 Litre Cooked / 6 Litre Dry. Dimensions: 345(H) x 460(W) x 400(D)mm. Model: J300-A.

Safety Tips

• Position on a flat, stable surface.
• Installation and repairs should be carried out by a qualified technician. Do not remove any components.
• Comply with Local and National Standards, including Health and Safety at Work Legislation, BS EN Codes of Practice, Fire Precautions, IEE Wiring Regulations, and Building Regulations.
• Do NOT immerse the appliance in water.
• Do not touch hot surfaces with bare hands. Always use protective gloves.
• Use extreme caution when moving or handling appliances containing hot oil or other hot liquid.
• Never fill the inner bowl above the top water line.
• Never allow water or any liquid into the outer pot.
• Only use provided utensils. Sharp objects may damage the non-stick coating of the inner bowl.
• Do not use the appliance for anything other than its intended use.
• Do not plug in the cable until ready to cook. The rice cooker's power remains ON unless unplugged.
• Always switch off and disconnect the power supply when not in use.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of packaging according to local authority regulations.
• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician to avoid a hazard.

Introduction

Please read this manual carefully. Correct maintenance and operation will provide the best performance from your BUFFALO product.

Pack Contents

• BUFFALO Rice cooker
• Measuring cup x 2
• Spoon
• Fork
• Instruction manual

BUFFALO prides itself on quality and service. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Operation

Cooking Tips

• Wash rice thoroughly before cooking to prevent sticking.
• A small amount of vegetable oil can help separate grains.
• Brown or wild rice may require additional water.

Using the Rice Cooker

The inner bowl has measurement lines. The provided cup measures rice and water.

Control panel features: Cook light, Keep Warm light, Lever.

1. Measure desired amount of rice using the measuring cup. Note: One cup of rice yields approximately two cups of cooked rice.
2. Rinse rice in a sieve under running water to remove excess bran and starch.
3. Pour rice into the inner bowl, spreading evenly.
4. Add correct amount of water using the measuring cup or by filling the inner bowl to the appropriate level. Note: Slightly reduce water for firmer rice, increase for softer rice.
5. Place the inner bowl into the rice cooker. Note: Ensure the outside of the inner bowl is dry.
6. Close the lid until the latch snaps shut.
7. Connect the rice cooker to the power.
8. Depress the lever to the COOK position. The Cook light turns on.
9. When cooking finishes, the switch automatically moves to the WARM position. The Warm light turns on.
10. Keep the lid closed for 10-15 minutes for best results.
11. Carefully open the lid, allowing steam and condensation to run back into the rice cooker. WARNING: Always take care to avoid steam expulsion when opening the lid. Always use heat-proof gloves when removing the inner bowl after cooking.
12. Stir and serve rice as quickly as possible.
13. Disconnect the appliance from the power supply.

Rice/Water Measurements

As a general guide, use one full cup of water for each full cup of rice. Adjust water for desired firmness.

Cleaning, Care & Maintenance

Note: Always switch off and disconnect the appliance from the power supply before cleaning. Always allow the appliance to cool before cleaning.

1. Remove the inner bowl and wash in warm, soapy water. Avoid harsh abrasive cleaners or products unsuitable for non-stick coatings.
2. Rinse and dry thoroughly.
3. Clean the exterior with a damp cloth.
4. Ensure the heating plate is clean and free of debris that could interfere with cooking.
5. Dry the heating plate thoroughly before use.
6. Remove the water collector from below the lid hinge by pulling outwards (See Figure 1). Discard collected water after each use.
7. Clean and replace the water collector.

Figure 1: Water collector removal.

Troubleshooting

Technical Specifications

Electrical Wiring

The plug is to be connected to a suitable mains socket.

Wiring:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed using a dedicated earthing circuit. Consult a qualified electrician if in doubt.

Ensure electrical isolation points are clear and accessible for emergency disconnection.

Compliance

The WEEE logo [WEEE recycling symbol] on this product indicates it must not be disposed of as household waste. Dispose of in an approved, environmentally safe recycling process. Contact the supplier or local authority for disposal information.

BUFFALO parts undergo strict product testing to comply with international, independent, and federal standards and specifications.

BUFFALO products have been approved to carry the following symbol: [Buffalo approval symbol].

All rights reserved. No part of these instructions may be reproduced without prior written permission from BUFFALO. BUFFALO reserves the right to change specifications without notice.

Declaration of Conformity

I, the undersigned, hereby declare that the equipment specified above conforms to the above Legislation and Standard(s).

Date: 09/03/11

Signature: Richard Cromwell

Position: Marketing Director

Notes

Document version: J300-A_A5_v1