Zalman S3 ATX Mid Tower Computer Case User Manual

Precautions

• Read this manual carefully before installing.
• Check the product and components before installing. If you find any abnormality, contact the location where you purchased the product for a replacement or refund.
• Wear gloves to prevent accidents when installing the product.
• Severe damage may occur when mounting the system, so do not apply excessive force.
• Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when connecting the cable.
• Be careful not to block the ventilation hole of the product when using the system.
• Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-ventilated location.
• Do not wipe the surface of the product using chemicals (organic solvents such as alcohol or acetone).
• Do not insert your hand or other object into the product during operation, as this may injure your hand or damage the object.
• Store and use the product out of children's reach.
• Zalman assumes no responsibility for any problem that occurs due to the use of the product for purposes other than its designated purposes and/or the carelessness of the consumer.
• The exterior design and specifications of the product are subject to change without prior notice to consumers for quality improvement.

Specifications

Component Identification

• A: Power button
• B: Microphone jack ?
• C: Headphone jack ?
• D: USB 2.0 ports
• E: USB 3.0 port
• F: Reset button
• G: Power LED indicator ?
• H: HDD LED indicator ?

Accessories Component

• Manual
• PCI Slot cover x 2
• Cable tie x 5
• USB Rubber cover x 3
• Media Rubber cover x 2
• HDD Screw x 8
• SSD / MB Screw x 18
• PSU / VGA Screw x 8
• Motherboard Stand-off x 3
• FAN Screw x 8

Installation Guide

1. Separating the side panel

   To remove the side panel, slide it outwards as indicated by the arrows.

2. Mounting the motherboard

   As 6 stand-offs are mounted by default, insert an additional stand-off according to the type of motherboard by referring to the mounting position of the main board, and mount the motherboard on the case. The diagram shows mounting positions for ATX, mATX, and Mini-ITX motherboards.

3. Mounting the 3.5" and 2.5" SSD / HDD

   Separate the tool-free 2.5" and 3.5" combo HDD guide and assemble the HDD or SSD. Mount the assembled HDD on the slot.

4. Mounting 2.5" SSD / HDD

   The diagram shows how to mount a 2.5" SSD or HDD on the right side of the case.

5. Mounting PCIE (VGA) card

   Loosen the screws, remove the PCI slot cover, mount the graphics card, and then secure it with the screws.

6. Mounting the top fan

   As shown in the picture, install the fan on the top of the case using bolts.

7. Mounting the bottom fan

   Install the fan on the bottom of the case using fan screws.

8. Mounting the front fan and front radiator

   After Front Cover Removal, mount the fan or the radiator on the mount hole in the front as shown in the figure. For liquid-coolers, only products with a hose length of 240 mm or more can be installed.

Warranty

1. Warranty Period: 1 year from the product manufacturing date. (However, if the purchase receipt is provided, it is 1 year from the product purchase date).
2. Free A/S: If a defect or malfunction occurs in the product's performance within the warranty period.
3. Paid A/S: If a problem occurs during product use after the warranty period. However, the following cases are not eligible for free A/S even within the warranty period and will be handled at the consumer's expense:
   • ① Failure to adhere to the precautions and notes specified in this user manual.
   • ② Deformation, breakage/destruction due to user's intent, negligence, or carelessness.
   • ③ Deformation and malfunction due to user's arbitrary modification.
   • ④ Removal or damage to the warranty sticker.
   • ⑤ Malfunction caused by current geological conditions (This point seems like a mistranslation, likely referring to environmental factors or power surges).
4. Product Exchange
   • Exchange and Repair: If a defect or malfunction occurs in the product's performance within the warranty period from the product manufacturing date.
   • ① Within 14 days from the purchase date - 1:1 exchange for a new product. (Requires proof of components and purchase details).
   • ② Within the warranty period - Free exchange and free repair.
   • ③ After the warranty period - Paid exchange and paid repair.
5. Parts Retention Period: 2 years from the product discontinuation date. (However, the discontinuation date is based on the final shipment date of the discontinued product.)
6. A/S Information
   • 1) Operating Hours:
     • ① Center operating hours: 10:00~17:00 (Closed on weekends and holidays)
     • ② Consultation operating hours: 10:00~16:00
   • 2) Reception Method:
     • ① Visit Reception: Apply for A/S after accessing www.zalmansvc.com and registering as a member. Please bring the product for which you applied.
     • ② Parcel Reception: Apply for A/S after accessing www.zalmansvc.com and registering as a member. Please send the parcel with the address, name, contact information, and symptoms accurately stated. (Check www.zalmansvc.com for the service center address.)
7. Transportation Costs
   • 1) In case of initial defect: Zalman will bear the round-trip shipping costs for initial defects.
   • 2) For free A/S: The customer is responsible for the round-trip shipping costs once (prepaid) within the free period.
   • 3) Paid A/S and after the warranty period: The customer is responsible for all round-trip costs.

I/O Port Connections

• Power SW
• Power LED
• Reset SW
• HDD LED
• USB 3.0
• HD Audio
• USB 2.0