GETKÅL LED Lighting Chain

Important Safety Information & Usage Guidelines

⚠️ WARNING!

• For INDOOR & OUTDOOR USE.
• Do not connect the chain to the supply while it is in the packing.
• The connecting cable cannot be repaired or replaced. If the cable is damaged, the entire fitting must be discarded.
• Do not connect this chain electrically to another chain.
• The light source of this luminaire is not replaceable. When the light source reaches its end of life, the whole luminaire shall be replaced.
• NON-REPLACEABLE BULB.
• CAUTION! Strangulation hazard. Hang out of reach of young children.
• ONLY USE A SAFETY TRANSFORMER AS SUPPLY FOR THE PRODUCT.
• For lighting chains which rely on gaskets to provide the specified degree of protection against dust, solid objects and moisture: WARNING – THIS LIGHTING CHAIN MUST NOT BE USED WITHOUT ALL GASKETS BEING IN PLACE.

Assembly and Connection

Step 1: Connect the power adapter or extension cable. Ensure the connector is securely screwed onto the threaded end of the cable.

Operating the Lighting Chain

The lighting chain is controlled by a single button on the control unit. Pressing the button cycles through different functions and settings:

• 1-8 presses: Cycle through 8 different lighting modes/effects (e.g., steady, flashing, fading).
• 9-11 presses: Cycle through 3 different color settings.
• 12 presses: Cycle through 3 different brightness levels.
• 13 presses: Cycle through 3 different timer settings.
• 14 presses: Turn the lights off.
• Press and hold for 5 seconds: Reset the control unit to its default settings.

Note: Some sequences may offer alternative ways to select color effects or modes. Always ensure all gaskets are properly in place for optimal protection.