VIKING Solar Panels

Instructions for Using the VIKING Solar System

1. Unfold the solar panel and expose it to direct sunlight without obstruction. Do not place it in the shade or in places where a shadow may appear later.
2. For maximum performance, the open solar panel should face directly towards the sun.

Tip: To achieve the maximum output power of the solar modules, it is recommended to set the solar modules to face south, following the sun's path.

Charging Battery Generators

When using VIKING solar panels to charge VIKING battery generators, follow these steps:

1. Remove the solar panel from its protective packaging and open it towards the sun.
2. Connect the solar cable with MC4 terminals to the corresponding MC4 solar terminals on the battery generator. (For VIKING L50, use the JACK 5.5 / 2.1 terminals).
3. If everything is connected correctly, the solar panel is open and producing energy, and the battery generator will start charging.

Warnings and Safety Precautions

• Do not disassemble the device or its accessories.
• Do not modify, disassemble, open, puncture, or otherwise tamper with the solar panel.
• Protect from fire, direct rain, and prolonged direct sunlight.
• Protect against high voltage equipment.
• Do not throw or shake the device.
• This appliance is not intended for use by persons (including children) whose physical, sensory, or mental disability, or lack of experience and knowledge, prevents them from using the appliance safely.
• Do not use chemical cleaners, etc. Ignoring these safety instructions may result in fire, electric shock, or damage to digital equipment.

Stop using this device immediately if it is damaged in any way. Keep out of reach of children.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.

Disposal and Recycling

Do not dispose of the product as unsorted municipal waste at the end of its useful life. Use separate waste collection points. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health. Recycling materials helps conserve natural resources. For more detailed information about recycling, please contact your local city office, household waste disposal service, or the shop where you purchased the product.

Loss of Warranty

The warranty expires under the following conditions:

• Damage due to improper use or use in unsuitable conditions.
• The current, voltage, or power of the PV or DC system is outside the nominal values of the solar panel.
• Attempt by the user to perform improper repair or disassembly.
• The solar panel or any part of it is damaged by natural elements, such as lightning, water, or mechanical damage.
• The solar panel or any part of it is damaged due to careless handling.

Declaration

All rights reserved. Reproduction of this document in any form and by any means without the written permission of BONA SPES s.r.o. is prohibited. All other trademarks are trademarks of their respective owners. Features and specifications are subject to change without notice.

Special Instructions for the VIKING SCM120 Solar Panel

For both horizontal and vertical panel mounting, the wiring box (on the back of the panel) should always be at the top. When mounting vertically, always try to keep the wiring box on top, otherwise water may be trapped in or around it.

• Use only stainless steel mounting parts. The groove for the cables and their fastening should be arranged at the bottom of the panel. Make sure that no water is trapped there.
• The installed panel must not cover any ventilation opening of the existing equipment on the roof.
• The working range of mounted satellite dishes and similar devices should also not be limited.
• The mounting surface must be flat; do not mount the device on a rounded or sloping surface.
• Despite the safe construction of this product, we recommend handling it with care.
• When installing the solar panel, ensure that wind cannot get under the solar panel and cause it to tear off or be damaged.

Cleaning Instructions

For cleaning the panels, rain usually suffices. If the surface of the panel is dirty with attached leaves, bird droppings, pollen, etc., we recommend cleaning it with a sufficient amount of water, but without detergent. It is best to use a garden hose and a soft object, such as a sponge or car wash brush. Never scrape or wipe dry dirt to avoid micro-scratches that can cause the performance of the device to decline or be permanently damaged.

Caution: Do not step on the panels during cleaning and handling.

Technical Specifications and Description of VIKING Panels

Diagram Descriptions:

VIKING L50 Solar Panel Components (Diagram 1)

• 1: Solar panel
• 2: Protective textile cover
• 3: Handle
• 4: Support legs
• 5: Charging cable pocket
• 6: Charging cable (5m)
• 7: MC4 connector

VIKING L80 and L110 Solar Panel Components (Diagram 2)

• 1: Solar panel
• 2: Protective textile cover
• 3: Handle
• 4: Support legs
• 5: Charging cable pocket
• 6: Charging cable (5m)
• 7: MC4 connector

VIKING LVP80 and LVP120 Solar Panel Components (Diagram 3)

• 1: Protective elements
• 2: Protective elements
• 3: Support legs
• 4: Solar panel
• 5: Cable clamps
• 6: Connecting hinges for solar panels
• 7: MC4 connector

VIKING LE60 and LE100 Solar Panel Components (Diagram 4)

• 1: Solar panel
• 2: MC4 connector

Manufacturer Information

VIKING products are distributed and serviced by: BONA SPES s.r.o., Řepčín 250, Olomouc 77900, Czechia. VAT No.: 03476774. Contact: +420 777 109 009, www.best-power.cz, info@best-power.cz.