Zoeller Pump Company
Replacement Parts List and Wiring Diagrams
This document provides a comprehensive replacement parts list and wiring diagrams for various Zoeller pump models featuring Permanent Split Capacitor (PSC) and Split Phase motor designs. It covers models including M267, N267, D267, E267, H267, I267, J267, F267, G267, and WM267.
Product information presented reflects conditions at the time of publication. Consult the factory regarding discrepancies or inconsistencies.
To Order Replacement Parts
Please furnish the following information:
- Model number
- Part number of the pump
- Part number and description of the specific part needed
Wiring Diagrams
The following describes the general wiring configurations for the listed pump models:
Diagram 1: Models M267, D267, H267, N267, E267, I267
This diagram illustrates the electrical connections for automatic and non-automatic pumps. It shows the wiring for the float switch ?, capacitor ⚡, motor (including overload protection O.L.), and power supply (L1, L2). The diagram details connections to the switch, relay, and motor terminals.
Diagram 2: Models WM267-C, WM267-D
This diagram shows the wiring for WM267 series pumps, including connections for a float switch and the motor assembly.
Diagram 3: Models J267, F267, G267
This diagram details the wiring for 3-phase models, illustrating connections for the float switch, capacitor, motor, relay, and power supply (L1, L2, L3).
Replacement Parts List
The following table lists common replacement parts. Note that specific part numbers may vary based on the model variant and manufacturing date. Please refer to the original documentation or consult Zoeller Pump Company for precise part numbers for your specific unit.
| REF NO. | DESCRIPTION | QTY | PART NUMBER (Representative) |
|---|---|---|---|
| 1 | CASE ASSEMBLY - AUTOMATIC | 3 | 004739 |
| 2 | COVER ASSEMBLY - NON-AUTOMATIC | 1 | 267051 |
| 3 | HANDLE | 1 | 267032 |
| 4 | CASE MACH. & GASKET - AUTOMATIC | 3 | 155781 |
| 5 | COVER MACH. & GASKET - NON-AUTOMATIC | 3 | 267052 |
| 6 | RETAINER - NON-AUTOMATIC | 2 | 267053 |
| 7 | GUARD - AUTOMATIC | 1 | 267008 |
| 8 | GASKET - CASE/COVER | 1 | 267007 |
| 9 | ARM AND SEAL ASSEMBLY | 1 | 004741 |
| 10 | SWITCH ASSEMBLY | 1 | 004740 |
| 11 | CAPACITOR ASSEMBLY | 1 | 155782 / 156952 |
| 12 | WIRE PACKAGE | 1 | 155783 |
| 13 | CORD SEAL AND STRAIN RELIEF ASSEMBLY | 1 | 155784 |
| 14 | CORD ASSEMBLY - STANDARD / 1 PHASE - 3 WIRE | 1 | 010925 / 155785 / 010926 / 156032 / 156033 |
| 15 | MOTOR HOUSING ASSEMBLY | 1 | 155786 / 156489 |
| 16 | STATOR WITH SCREWS | 1 | 155787 / 156490 / 155961 / 156491 / 156034 / 156959 |
| 17 | THRU WALL TERMINALS | 3 | 003402 |
| 18 | TEST PLUGS | 2 | 034090 |
| 19 | ROTOR ASSEMBLY | 1 | 155788 / 156955 |
| 20 | THRUST WASHER | 1 | 002140 |
| 21 | DIELETRIC OIL | 1 | 267056 |
| 22 | MOTOR HOUSING SEAL | 1 | 267006 |
| 23 | PUMP HOUSING - MACH. | 1 | 003877 |
| 24 | SHAFT SEAL ASSEMBLY | 1 | 267027 |
| 25 | IMPELLER - PLASTIC | 1 | 150857 |
| 26 | IMPELLER - CAST IRON | 1 | 003884 |
| 27 | BASE | 1 | 008646 |
| 28 | FLOAT | 1 | 034019 |
| 29 | FLOAT ROD | 1 | 001526 |
| 30 | FLOAT ROD GUIDE ASSEMBLY | 1 | 004676 |
| 31 | SCREW - CASE & BASE (1/4-20 X 3/4" LONG) | 9 | 001916 |
| 32 | SCREW - SWITCH (#6-32 X 7/16" LONG) | 2 | 004644 |
| 33 | SCREW - GROUND & CAPACITOR (#6-32 X 1/4" LONG) | 1 | 001877 |
| 34 | SCREW - MOTOR HOUSING (1/4-20 X 7/8" LONG) | 4 | 012491 |
| 35 | SCREW - STATOR (#8-32 X 3 1/16" LONG) | 2 | 154768 |
| 36 | SCREW - GUARD & RETAINERS/GUIDE (#10-24 X 3/8" LONG) | 3 | 001883 |
| 37 | NUT, 5/16-24UNF SS ACORN/LOW CROWN | 1 | N/A |
| - | REBUILD KIT | 1 | 155789 |
Service Part Notes
- If an "X" follows model no., or date mfg. on ID tag, consult factory for ordering any parts.
- See FM0160 Parts Price Sheet for listing of part prices.
- "N/A" indicates not applicable.
- Strain relief clamp is not sold separately; must order cord seal assembly.
- Cut plug off if required.
For illustrations, please refer to the original document pages: Page 6 for M267/N267/D267/E267/H267/I267, Page 9 for M267/D267/H267, and Page 11 for N267/E267/I267/J267/F267/G267. The WM267 illustration is on Page 13.
Visit Zoeller Pump Company at zoellerpumps.com.
Copyright 2022 Zoeller® Co. All rights reserved.
