Key Features
- Energy saving product
- 2-year warranty
- Reliable integrated vertical switch
- 1/2 HP, 115 V sump pump
- Performance up to 25' (7.6 m) TDH
- Flows up to 50 GPM (189 LPM)
- Rugged cast iron motor housing
- Engineered plastic base
- Corrosion-resistant, powder coated epoxy paint
Product Dimensions & Specifications
General Dimensions:
- Overall Height: 12-3/8" (314 mm)
- Discharge Size: 1-1/2" NPT
- Various widths/depths are provided in diagrams, including 2-11/16" (68.3 mm), 2-25/32" (70.6 mm), 4-1/2" (114.3 mm), 2-9/16" (65.1 mm), and top dimensions of 5-13/32" (137.3 mm) and 3-15/16" (100 mm).
Motor Specifications
| Attribute | Value |
|---|---|
| Horse Power | 1/2 |
| Voltage | 115 V |
| Phase | 1 Ph |
| Hertz | 60 Hz |
| RPM | 3450 |
| Type | Permanent split capacitor |
| Insulation | Class B |
| Amps | 5.6 |
Pump Specifications
| Attribute | Value |
|---|---|
| Operation | Automatic |
| Auto On/Off Points | 8-1/4" (21 cm) / 2-1/2" (7 cm) |
| Discharge Size | 1-1/2" NPT |
| Solids Handling | 3/8" (9 mm) spherical solids |
| Cord Length | 10' (3 m) standard |
| Cord Type | UL listed, 3-wire, grounded plug |
| Max. Head | 25' (7.6 m) |
| Max. Flow Rate | 50 GPM (189 LPM) |
| Max. Operating Temp. | 104 °F (40 °C) |
| Cooling | Oil filled |
| Motor Protection | Auto reset thermal overload |
| Motor Housing | Cast iron |
| Pump Housing | Engineered plastic |
| Base | Engineered plastic |
| Upper Bearing | Ball bearing |
| Lower Bearing | Ball bearing |
| Mechanical Seals | Carbon and ceramic |
| Impeller Type | Non-clogging vortex |
| Impeller | Engineered plastic |
| Hardware | Stainless steel |
| Motor Shaft | SUS420J2 stainless steel |
| Gasket | NBR |
Pump Performance Curve
The pump performance curve illustrates the relationship between Total Dynamic Head and Flow Rate for the Model 75 sump pump.
The graph shows Total Dynamic Head in feet (0-30) and meters (0-8) on the vertical axis, and Flow Rate in gallons per minute (0-60) and liters per minute (0-160) on the horizontal axis. The curve indicates that the pump can deliver approximately 50 GPM (189 LPM) at 10 feet (3 m) of head, and approximately 25 GPM (95 LPM) at 25 feet (7.6 m) of head.
Certifications and Compliance
The product is certified to CSA Standard 227875. It features an "ENERGY SAVING PRODUCT" designation and is "TOUGH COATED" with "POWDER COATED" epoxy paint for corrosion resistance.
Important Safety Information
CAUTION: All installation of controls, protection devices, and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed, including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
