Pesaro Tracklight Installation Manual
Product Code: ML31, ML32 | Mondolux.com.au
Brand: Mondolux
Notes
- This fitting requires 100-240V AC/50Hz power input to the driver.
- Installation must be performed only by a qualified electrician. Do not interchange any parts of this fitting.
- Do not touch the fitting when in use. Ensure it is disconnected from AC supply.
- This luminaire is to be installed on a 4-wire/3-phase track rail.
- For any questions about the installation of this product, please contact Mondolux.
Dimensional Information: Key dimensions provided include 61.4mm, 11.2mm, and 41.7mm. A length of 600mm is indicated for the luminaire body, and a 1500mm length is shown, likely representing a track segment.
Installation Steps
- Ensure the mains power is turned off.
- Adjust the luminaire as per desired power and phase settings. Refer to Pictures 1 and 2 for guidance.
- Secure the luminaire by inserting the track adaptor into the track and locking the knobs. The luminaire is compatible with most standard tracks, including the Mondolux Brand. Refer to Pictures 3 and 4.
- The driver can be adjusted to 4 different positions, and the fixing lock can be adjusted to 2 positions. Ensure the driver and fixing lock are adjusted accordingly when connecting to a continuous track system to avoid installation on track joints. Refer to Pictures 5 through 10 for detailed adjustment guidance.
- Installation is complete.
Component Identification:
- 1: Ground point
- 2: Adaptor knob
- 3: Phase selector
- 4: Ground pin
- 5: Power selector
- 6: LED driver
- 7: Wires lock
- 8: Wires box
- 9: Fixing lock
- 10: Fixing knob
- 11: End cap
- 12: Track rail
- 13: Suspension kit
Diagrammatic Guidance:
Pictures 1 & 2: Illustrate luminaire adjustment for power and phase settings.
Pictures 3 & 4: Show the track adaptor insertion and locking mechanism, highlighting compatibility with standard tracks.
Pictures 5-10: Provide detailed instructions on adjusting the LED driver and fixing lock positions to avoid track joints:
- Picture 5: General illustration of track installation, emphasizing avoiding track joints by adjusting the LED driver or fixing lock positions.
- Picture 6: If the fixing lock position is interfered, slide it to the right or left to avoid the track joint.
- Picture 7: If the LED driver is interfered, expose the wires from the wire box by moving it to the right.
- Picture 8: Slide the driver to the right or left to avoid the track joint.
- Picture 9: Slide the wire box close to the newly adjusted driver position and put the exposed wires back into the wire box.
- Picture 10: Install the luminaire by successfully avoiding the track joints.
