Pesaro Maxi Adjustable Tracklight

Installation Notes

• This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by a qualified electrician.
• Electrical wiring and installation should always comply with local standards.
• Do not open or interchange any parts of this fitting, or the warranty is void.
• The fitting may be hot to touch after continuous use.
• Do not install the fitting near a heat source.
• Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
• If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.

Care & Refinishing

Mondolux strongly recommends following cleaning procedures to maintain the proper finish of the product.

• Do not use bleach or concentrated solvents under any circumstances.
• For Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.

Product Dimensions

Linear Dimensions:

Overall Length: 1500mm

Width: 61.4mm

Height: 61.4mm

Detail Dimension: 11.2mm

Detail Dimension: 41.7mm

Tilt Angle:

Maximum tilt angle: 30 degrees (on each side)

Detail Dimension: 55.7mm

Detail Dimension: 11.2mm

Installation Steps

1. Ensure the mains power is turned off.
2. Make sure the luminaire is set to desired power and phase settings. Refer to Pictures 1 and 2.
3. Click the track adaptor into the track and secure it by locking the knobs. The luminaire is compatible with most standard tracks, including the Mondolux brand. Refer to Pictures 3 and 4.
4. The luminaire can be tilted to a desired angle up to 30 degrees on each side. To tilt, secure the luminaire onto the track and gently pull it downwards. Then, tilt forward or backward as required. Refer to the technical drawing on Page 1.
5. The driver can be adjusted to 4 different positions. The fixing lock can be adjusted in 2 positions. Ensure the driver and fixing locks are adjusted accordingly when connecting to a continuous track system to avoid installation on track joints. Refer to Pictures 5 through 10.
6. Installation is complete.

Illustrations and Diagrams

Picture 1 & 2: These images show how to set the luminaire's power and phase settings.

Picture 3 & 4: These images display various components: Track adaptor, adaptor knob, phase selector, ground pin, power selector, LED driver, wires lock, wires box, fixing lock, fixing knob, end cap, track rail, and suspension kit.

Picture 5: This diagram illustrates the importance of avoiding track joints during installation by adjusting the LED driver or fixing lock positions.

Picture 6: This image demonstrates how to slide the fixing lock to the right or left to avoid a track joint if it interferes with installation.

Picture 7: This image shows how to expose wires from the wire box by moving it to the right, if the LED driver is interfered with.

Picture 8: This image shows how to slide the LED driver to the right or left to avoid a track joint.

Picture 9: This image shows moving the wire box close to the newly adjusted driver position and placing the exposed wires back into the wire box.

Picture 10: This image depicts the final step of successfully installing the luminaire while avoiding track joints.