Rho Mini

Notes

• This fitting requires 220-240V AC/50Hz power input to the driver. Installation should be done by a qualified electrician.
• Electrical wiring and installation should always comply with local standards.
• Do not open or interchange any parts of this fitting, or the warranty is void.
• The fitting may be hot to touch after continuous use.
• Do not install the fitting near a heat source.
• Do not install any inductive loads such as exhaust fans or pond pumps etc. within the same lighting circuit of this fitting. Issues caused by such wirings are not covered under our warranty policy.
• Wherever applicable, waterproof cable joints like junction boxes or heavy-walled adhesive-lined heat shrinks must be used, or warranty is void.
• If you have any questions about the installation of this product, please contact Mondolux at 1300 601 931.

Care & Refinishing

Mondolux strongly recommends following cleaning procedures to maintain the proper finish of the product.

• Do not use bleach or concentrated solvents under any circumstances.
• For Black finish: Wipe gently with a soft damp cloth or chamois. Do not use any abrasive compounds.

Product Dimensions

A diagram showing the dimensions of the Rho Mini outdoor wall light. The fitting is cylindrical with a flat top and bottom. Key dimensions are indicated: height is 140mm, width at the base is 87mm, and the diameter of the main body is 55mm. The depth or projection from the wall is 90mm.

Installation Steps

1. Ensure the mains power is turned off.
2. Drill required number of holes into the wall. See Picture 1.
3. Fix the mounting base using the provided screws. Pass the power supply cable through the gasket of the mounting base and secure it. See Picture 2.
4. Connect the wires on the supply side to the respective terminals of the Luminaire. See Picture 3.
5. Use the grub screws and allen key provided to secure the main luminaire to the mounting base. See Picture 4.
6. Installation is complete. Turn the mains on. See Picture 5.

Diagram Descriptions:

Picture 1: Illustration showing the outdoor wall light fitting next to a wall with two holes drilled. A measurement of 65mm is indicated between the centers of the holes.

Picture 2: Diagram illustrating the mounting base being fixed to the wall with screws. A power supply cable is shown passing through a rubber gasket in the mounting base. Components labeled '1-1' and '1-2' are depicted, likely representing electrical connectors or cable management parts.

Picture 3: Illustration showing the internal wiring connections. Wires from the power supply are connected to the terminals on the luminaire.

Picture 4: Diagram showing the main luminaire body being attached to the mounted base. Grub screws and an allen key are shown, indicating how the fitting is secured.

Picture 5: Illustration of the fully installed Rho Mini outdoor wall light on the wall. Two small indicators are shown on the fitting, labeled '5-1' and '5-2', with 'ON' and 'OFF' positions indicated, suggesting a power status or control.

Certifications

The product carries the following certifications: CE, RoHS, and IP65 rating.