BESTÅ TV Bench Assembly Instructions
Safety First ⚠️
WARNING: Furniture tip-over can cause serious or fatal crushing injuries. To prevent tip-over, this furniture must be secured to the wall using the provided wall attachment devices. Screws and plugs for the wall are not included and must be purchased separately, suitable for your wall type. Always follow each step of the instructions carefully.
This manual is provided in multiple languages. Please refer to the English section for primary instructions.
Assembly Steps
Step 1: Attach Feet
Attach the six feet (parts 114947, 115988) to the underside of the base panel using six screws (part 100006).
Step 2: Assemble Base and Sides
Insert twelve dowels (part 130618) into the designated holes on the base panel and side panels. Connect the side panels to the base panel using eight cam locks (parts 118137, 122971, 141028, 130725, 119253) and screws (parts 130619, 130722, 141027, 130723, 130620).
Step 3: Attach Back Panel Supports
Attach the back panel supports (part 144342) to the rear of the side panels using screws (part 113287).
Step 4: Insert Shelves
Insert shelf support pins and place the shelves into the unit.
Step 5: Attach Top Panel
Attach the top panel to the side panels using cam locks and screws.
Step 6: Attach Wall Mounting Brackets to Unit
Attach three wall mounting brackets (part 103693) to the top rear of the unit using screws (part 113287). Attach three corner brackets (parts 144343-144347) to the bottom rear of the unit.
Step 7: Assemble UPPLEVA Mount Components
Assemble the UPPLEVA TV mount components, including brackets (e.g., 133209, 133203, 144567) and clips (e.g., 115444), using the provided screws and hardware.
Step 8: Attach Mounting Rails
Attach the two long mounting rails (parts 144348, 144349, 144350) to the top of the assembled unit using screws (e.g., 10093069, 133203).
Step 9: Route Cables
Route cables through the designated channels and openings in the unit.
Step 10: Wall Mounting - Brackets
Determine the desired height and position on the wall. Mark the wall for the wall brackets. Drill holes and insert appropriate wall plugs (not included). Secure the wall brackets to the wall using suitable screws (not included). Ensure brackets are level.
Step 11: Mount Unit to Wall
Lift the assembled TV bench and hook it onto the wall brackets. Ensure it is securely attached, often with an audible 'click'.
Step 12: Attach TV Mount to Unit
Attach the UPPLEVA TV mount arm and associated components to the mounting rails on the unit using screws (e.g., 118137, 122971, etc.).
Step 13: Attach TV to Mount
Mount the television onto the UPPLEVA TV mount arm according to the UPPLEVA instructions (referencing pages 7-15, 23-27).
Step 14: Final Adjustments
Adjust the height and position of the TV mount as needed. Ensure all screws are tightened and the unit is stable.
Parts Overview
The following key components are included:
- 6x Feet (e.g., 114947, 115988)
- 12x Dowels (e.g., 130618)
- 8x Cam Locks (various numbers)
- Various screws (e.g., 100006, 113287, 116637, 130618, 130619, 130722, 141027, 130723, 130620)
- 1x Hex key (e.g., 130693)
- 3x Wall mounting brackets (e.g., 144342)
- 3x Top rear brackets (e.g., 103693)
- 3x Corner brackets (e.g., 144343-144347)
- UPPLEVA TV mount components (various parts including rails, arms, brackets, clips)
