TVÄRDRAG Lamp

Important Safety Instructions

For indoor use only.

Regularly check the cord, the transformer and all other parts for damage. If any part is damaged, the product should not be used.

Important information! Keep these instructions for future use.

Light Source & Cord

• The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.
• The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.

Electrical Supply

• ⚠️ ONLY USE A SAFETY TRANSFORMER WITH A SELV OUTPUT AS A SUPPLY FOR THE PRODUCT.
• Use only IKEA LED drivers suited for this product. The total wattage of the lamps connected to one LED driver must not exceed the maximum power stated on that LED driver and never more than 30W.

Assembly & Usage

1. Wipe the surface dry where the tape will be used with a clean and dry cloth.
2. The assembly tape is permanent and is not intended to be removed. You might damage the surface under the lamp if you try to remove the tape.
3. Please keep the unused fittings for future use.

Precautions

⚠️ CAUTION! Do not cover. Lamp gets hot, may cause fire.

? WARNING – THIS IS AN ELECTRIC LAMP – NOT A TOY! TO AVOID RISK OF FIRE, BURNS, PERSONAL INJURY AND ELECTRIC SHOCK, IT SHOULD NOT BE PLAYED WITH OR PLACED WHERE SMALL CHILDREN CAN REACH IT.

Assembly Steps

The following steps describe how to assemble and install the TVÄRDRAG lamp. Ensure you have all parts before starting.

Parts Included

• Mounting Plate (Part No. 10084763) - 1x
• Screws (Part No. 108553) - 2x
• Lamp Arm Assembly (includes lamp head and power box)

Step 1: Prepare Mounting Surface

Diagram shows a hand wiping a surface with a cloth. This indicates preparing the surface where the mounting plate will be attached. Ensure the surface is clean and dry.

Step 2: Attach Mounting Plate

Diagram shows the mounting plate (10084763) being attached to a surface, likely a shelf or cabinet, using two screws (108553). The screws are shown being driven into the surface. The diagram also shows an inset of the surface preparation step.

Step 3: Attach Lamp Arm

Diagram shows the lamp arm assembly being connected to the mounted plate. An arrow indicates the direction of attachment. An inset shows a hand cleaning the surface again before attaching the lamp.

Step 4: Secure Lamp Arm

Diagram shows the lamp arm being secured to the mounting plate. This might involve clipping or screwing it into place. The diagram shows the lamp arm being positioned and potentially locked onto the plate.

Step 5: Connect Power

Diagram shows the power box of the lamp arm. An inset shows the connection point for the power cable. The power cable is shown being plugged into the power box. Another diagram shows the power cable being neatly bundled with a tie.

Step 6: Final Connection

Diagram shows the lamp arm connected to the power box. The power cable is shown plugged into a power outlet. The lamp head is shown in its final position.

Step 7: Cable Management

Diagrams show how to manage excess cable, tying it up neatly to prevent hazards and keep the area tidy. This is particularly relevant for preventing strangulation hazards.

Product Specifications & Notes

• The LED driver and power supply cord are sold separately.
• Maximum of 6 units can be connected to a single LED driver.
• Ensure the total wattage does not exceed the driver's maximum or 30W.

Safety - Cord Management

Diagrams illustrate the importance of securing cords to prevent strangulation hazards. They show how to attach the cord to walls or cabinets and tie up any slack to keep it out of reach of children.