Hyundai H-VCC09 Vacuum Cleaner
Instruction Manual
Parts List
- 1. Wheel
- 2. Dust collector
- 3. Dust collector handle
- 4. Dust collector cover
- 5. Sucking inlet
- 6. Dust collector bottom release button
- 7. Dust collector bottom
- 8. Dust collector lock button
- 9. ON/OFF button
- 10. Power cord winding button
- 11. Power level selector
- 12. Outlet HEPA filter
- 13. Main HEPA filter
- 14. Filter sponge
- 15. FLOOR/CARPET nozzle
- 16. FURNITURE nozzle
- 17. SLOT nozzle
- 18. Retractable tube
- 19. Retractable tube length adjuster
- 20. Hose
- 21. Hose locks
- 22. Hose base
- 23. Hose air flow control switch
- 24. Power cord and plug
Technical Specifications
Voltage: 220-240 V ~ 50 Hz
Protection Class: II
Power: 1800 W
Weight: 3.8 / 4.5 kg
Dimensions are approximately 250 mm (width), 290 mm (depth), and 330 mm (height).
Diagram Description: The diagram illustrates the main components of the vacuum cleaner, including the body, hose, telescopic tube, and various nozzles, along with key dimensions.
Important Safeguards
- Read this manual carefully before use to prevent any unit damage or injury.
- When using this appliance, basic precautions should always be followed.
- Before first use, check that the voltage indicated on the rating label corresponds to your home's mains voltage.
- For home use only. Do not use for industrial purposes.
- To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids. If this happens, DO NOT TOUCH the appliance, unplug it immediately, and seek service.
- Do not handle the plug with wet hands. Never switch off by pulling the cord.
- Do not let the cord hang over sharp edges or touch hot surfaces.
- Always unplug the appliance from the power supply when not in use and before servicing.
- If the power cord is damaged, it must be replaced by the manufacturer, service department, or a similarly qualified person to avoid danger.
- To avoid deforming plastic components or causing a fire accident, never leave the appliance exposed to direct sunlight or near any heater.
- The appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities (including children) or those lacking experience or knowledge, unless they are supervised or have been instructed by a responsible person.
- Children must be supervised to prevent them from playing with the appliance.
- To avoid damage to the flexible hose, do not fold or pull it strongly.
- Do not put any object into air outlets. Do not use with blocked outlets. Keep them free of dust, hair, and anything that may reduce airflow.
- Be careful when cleaning on stairs.
- Before starting, remove all large or sharp objects from the floor to prevent damage to the unit.
- CAUTION: To avoid voltage overload, do not plug the unit and other powerful electrical appliances into the power supply at the same time.
- Never use the vacuum cleaner without filters.
- Do not use the appliance on wet surfaces; this unit does not absorb water.
- If you have cleaned a carpet with liquid detergent, allow it to dry completely before vacuuming.
- Never use the appliance without a dust bin. Replace the dust bin without delay if it is damaged.
- Do not attempt to repair, adjust, or replace parts yourself. Contact the nearest service center for malfunctioning appliances.
- If the product has been exposed to temperatures below 0°C, it should be kept at room temperature for at least 2 hours before turning it on.
- The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless such changes significantly influence the product's safety, performance, and functions.
- Manufacturing date is indicated on the unit and/or packing in the format XX.XXXX (Month.Year).
Vacuum Cleaner Assembling & Preparation for Use
The device is intended for cleaning dust from premises, furniture, cars, drapes, cracks, and decorative surfaces.
- Assembling the Hose: Insert the flexible hose into the air inlet and press until it clicks into position. To remove the hose, press the button on the hose base and pull.
- Telescopic Tube: Extend the telescopic tube to the desired length. Insert the hose handle into the tube.
- Attaching Nozzles: Attach a nozzle to the tube. The Floor/Carpet nozzle is for cleaning bare floors and floor coverings. The Crevice-Furniture nozzle is for cleaning sofas, curtains, dust on decorative surfaces, corners, and between cushions. For furniture cleaning, turn the nozzle in the direction shown by the arrow.
- Starting Operation: Before starting, unwind the power cord to sufficient length (the yellow mark indicates optimal length; do not unwind beyond the red mark) and insert the plug into the power supply.
- Turning On/Off: Press the ON/OFF button to switch the unit on; press again to stop.
- Air Flow Regulator: Located on the hose handle, this allows you to adjust the suction power. Decrease flow for cleaning curtains, books, furniture, etc. Increase flow for cleaning bare floors.
- Power Control: The power control on the housing also adjusts suction power.
- Cord Rewind: Press the rewind button and guide the cord with your hand to ensure it does not whip, causing damage.
- Operating Time Limit: To prevent motor overheating, do not work continuously for longer than 30 minutes and take a break of at least 15 minutes between uses.
- Pre-Operation Check: Remove any sharp objects from the floor that could damage the dust collector before starting work.
- Do not connect the appliance to the same power outlet as other high-power electrical appliances to avoid overloading the power supply.
- Never operate the vacuum cleaner without filters installed.
- Do not use the appliance on wet surfaces; this unit does not absorb water.
- If you have cleaned carpets with liquid detergent, allow them to dry completely before vacuuming.
Advantages of Your Vacuum Cleaner
Your vacuum cleaner features a five-level air filtration system:
- A three-layer cloth dust collector.
- A fine fiber filter installed between the dust collector compartment and the electric motor.
- A fine fiber air outlet filter.
- Five layers of filtering materials deliver exceptional cleaning performance.
Care and Cleaning
- Switch off the appliance and pull the plug from the power supply.
- Clean the appliance's outside surface with a soft cloth using a mild, non-abrasive detergent.
- The vacuum cleaner or cord should never be immersed into water or any liquids.
- Dust Bag Cleaning:
- Clean the cloth dust bag regularly to ensure a long life. When the dust bag is full, the mechanical indicator moves to the middle of the window. When it stops there, clean the dust bag.
- Remove the flexible hose, open the front cover, take off the dust bag, slide aside a clamp on its lower edge, empty and close the dust bag, then place it back.
- Close the front cover by pressing down until it clicks.
- CAUTION: If the dust bag is not fixed properly, the cover lock clips cannot be locked.
- Filter Cleaning:
- Clean the filters at least once a year. If you use the appliance frequently, wash the filters after 3-5 dust bag cleanings.
- Switch off the appliance and pull the plug from the power supply.
- Open the cover and remove the motor filter.
- Take off the filter from the air outlet.
- Wash the filters with warm water and dry them completely in the air.
- Place the filters back.
- CAUTION: Never use the vacuum cleaner without filters. Do not use a washing machine to rinse filters or a hairdryer to dry them.
Storage
- Place the appliance vertically.
- Holding the handle, rotate the hose around the tube.
- Insert the tube into a special holder on the body.
Disposal Information
The symbol on the unit, packing materials, and/or documentation means that used electrical and electronic units and batteries should not be disposed of with ordinary household garbage. These units should be taken to a special receiving point.
For additional information about the actual system of garbage collection, address your local authority.
Valid utilization will help to save valuable resources and avoid negative impacts on public health and the environment that may occur from incorrect garbage disposal.