Bresser Climate Monitor User Manual

About This Product

This document is the user manual for the Bresser Climate Monitor, a device that measures temperature and humidity.

The device displays current temperature, humidity, and a comfort indicator based on these readings. It can also automatically set the time via radio signal.

Publisher Information

Bresser GmbH

Gutenbergstr. 2

46414 Rhede

Germany

www.bresser.de

© 2023 Bresser GmbH. All rights reserved.

Reproduction of this documentation, even partially, is prohibited without prior written authorization from the manufacturer.

Trademarks and designations used are protected by commercial, trademark, and patent law.

Validity Note

This documentation is valid for products with the following article numbers:

• 7000016000000

Manual Version: 0123

General Safety Instructions

[DANGER] Risk of Choking!

Incorrect use of this product can lead to suffocation, especially for children. It is imperative to follow the safety instructions:

• Keep packaging materials (plastic bags, elastics, etc.) out of reach of children!
• This product contains small parts that can be swallowed by children! Risk of choking!

[DANGER] Risk of Electric Shock!

This device contains electronic components powered by an energy source (mains adapter and/or batteries). Incorrect use can cause electric shock, leading to severe or fatal injuries. It is imperative to follow the safety instructions:

• Never leave children unsupervised when handling the device! Follow instructions carefully and do not attempt to power the device with sources other than those recommended in this manual, as this poses a risk of electric shock!

[DANGER] Risk of Fire/Explosion!

Incorrect use can lead to a fire. It is essential to observe the following safety information to prevent fires:

• Do not expose the device to excessively high temperatures. Use only the recommended batteries. The device and batteries must not be short-circuited or thrown into fire! Overheating or improper handling can trigger short circuits, fires, or even explosions!

[INFORMATION] Risk of Material Damage!

Improper handling can cause damage to the device and/or accessories. Therefore, use the device only in accordance with the following safety instructions:

• Do not disassemble the device! In case of a defect, contact your dealer. They will contact the service center and arrange for the device's return for repair if necessary.
• Do not immerse the device in water.
• Do not expose the device to shocks, vibrations, dust, prolonged high temperatures, or extreme humidity. This can lead to malfunctions, short circuits, and damage to batteries and components.
• Use only the recommended batteries. Always replace weak or empty batteries with a complete set of new, fully charged batteries. Do not use batteries of different brands, types, or capacities. Remove batteries if the device will not be used for an extended period!
• Do not use rechargeable batteries (accumulators).

[INFORMATION] Risk of Overvoltage Damage!

The manufacturer disclaims any liability for damage resulting from improper power supply due to incorrectly inserted batteries!

Parts Overview and Delivery Contents

Figure 1: All parts of the thermo-hygro sensor

Delivery Contents:

• 3 x Thermo-hygrometer (A)

Also required (not included in delivery):

• 3 x AAA / LR03 type batteries

Display Overview

Figure 2: Display indicators for the thermo-hygrometer

Operation

Powering On

1. Remove the battery compartment cover.
2. Insert batteries into the designated compartment, ensuring correct polarity (+/-).
3. Replace the battery compartment cover.

Automatic Time Setting

Once powered on, the clock automatically searches for the radio signal, which takes approximately 3 to 8 minutes to complete.

If the radio signal is received correctly, the date and time are automatically set, and the radio signal icon lights up.

If no signal is received, follow these steps:

1. Press the RCC button for approximately 2 seconds to reactivate radio signal reception.
2. If the device still does not receive the signal, the time must be set manually.
3. To deactivate automatic time reception, press and hold the RCC button for approximately 3 seconds.

Manual Time Setting

1. In normal display mode, press the SET button for approximately 3 seconds to enter time setting mode.
2. The digits to be set will flash.
3. Press the UP or DOWN button to change the value.
4. Press the SET button to confirm and move to the next setting.
5. Setting sequence: Time Zone Offset > Hours > Minutes > Year > Month > Day > Language.
6. Finally, press the SET button to save the settings and exit configuration mode.

For more information on displaying the time in 12 or 24-hour mode, refer to the chapter "Display Change".

Automatic Measurement Display

Once powered on, the current environmental readings are displayed on the device.

Comfort Indication

The climate indicator is a visual display based on temperature and air humidity to determine the comfort level.

Note: The comfort display may vary at the same temperature depending on humidity.

Display Change

• In normal display mode, press the SET button to switch between time and date.
• In normal display mode, press the UP button to toggle between °C and °F for temperature units.
• In normal display mode, press the UP button to switch between 12-hour and 24-hour time display.

Recycling

Dispose of packaging materials according to their type. Information on proper disposal can be obtained from the municipal waste disposal service or environmental agency.

Never dispose of electrical appliances with household waste! [Battery Disposal Symbol]

In accordance with European Directive 2012/19/UE on waste electrical and electronic equipment, used electrical equipment must be collected separately and recycled ecologically.

Batteries and rechargeable batteries must not be disposed of with household waste. You are legally obliged to return used batteries and accumulators. You can return them free of charge after use, either at our point of sale or nearby (e.g., in shops or municipal collection points).

Batteries and rechargeable batteries are marked with the symbol of a crossed-out bin and the chemical symbol of the pollutant. "Cd" signifies cadmium, "Hg" signifies mercury, and "Pb" signifies lead.

[Cadmium Symbol] [Mercury Symbol] [Lead Symbol]

Warranty

The normal warranty period is 2 years, starting from the day of purchase. To benefit from an extended warranty period (optional service) as indicated on the gift box, registration on our website is required.

You can consult the full warranty conditions and information on warranty extension and our services at the following link:

www.bresser.de/garantiebedingungen

CE Declaration of Conformity

Hereby, Bresser GmbH declares that the equipment type bearing article number 7000016000000 conforms to Directive 2014/53/UE. The full text of the EU declaration of conformity is available at the following internet address: www.bresser.de/download/7000016000000/CE/7000016000000_CE.pdf

Technical Data

• Power Supply: 1x AAA / LR03 battery
• Temperature Unit: °C or °F are selectable
• Temperature Display Range: -9.9°C to +50°C
• Humidity Display Range: 1% RH to 99% RH

Service Contact Information

For questions or claims regarding the product, please contact the service center, preferably by email.

Germany, Austria, Switzerland, Belgium:

E-Mail: service@bresser.de

Phone: +49 28 72 80 74 210

Netherlands, Belgium:

E-Mail: info@bresserbenelux.nl

Phone: +31 528 23 24 76

United Kingdom, Ireland:

E-Mail: service@bresseruk.com

Phone: +44 1342 837098

France, Belgium:

E-Mail: sav@bresser.fr

Phone: 00 800 6343 7000

Spain, Portugal:

E-Mail: servicio.iberia@bresser-iberia.es

Phone: +34 91 67972 69