Bresser Climate Smile Digital Thermometer Hygrometer

About this Instruction Manual

NOTICE

These operating instructions are to be considered a component of the device. Read the safety instructions and the instruction manual carefully before using this device. Keep these instruction manuals in a safe place for future reference. If the device is sold or passed on, the instruction manual must be passed on to any subsequent owner/user of the product.

Features

• Thermo-/hygrometer Set of 2
• Indoor climate indicator as a smiley ?
• Indoor temperature (in °C/°F)
• Relative humidity (indoor, in %)
• DCF time (12- or 24-hour display) and date
• Can be placed on a tabletop or mounted to the wall
• Dimensions: 110 x 13 x 94 mm
• Batteries: 4x CR2032 (2 per station)

General Safety Instructions

DANGER Danger of suffocation!

Improper use of this product may result in suffocation, especially for children. It is therefore imperative that you observe the following safety information.

• Keep packaging materials (plastic bags, rubber bands, etc.) away from children! There is a danger of choking! ⚠️
• This product contains small parts that can be swallowed by children! Choking hazard! ⚠️

DANGER Risk of an electric shock!

This device contains electronic parts that are powered by a power source (AC adapter and/or batteries). Improper use of this product may result in electric shock. Electric shock can cause serious or fatal injuries. It is therefore imperative that you observe the following safety information.

• Never leave children unattended when handling the device! Follow the instructions carefully and do not attempt to power this device with anything other than power sources recommended in this instruction manual, otherwise there is a danger of an electric shock! ⚡

DANGER Explosion hazard!

Improper use of this product may result in fire. It is essential that you observe the following safety information in order to avoid fires.

• Do not expose the device to high temperatures. Use only the recommended batteries. Do not short-circuit the device or batteries, or throw them into a fire! Excessive heat or improper handling could trigger a short-circuit, a fire or an explosion! ?

NOTICE Danger of material damage!

Improper handling may result in damage to the unit and/or accessories. Therefore, use the device only in accordance with the following safety information.

• Do not disassemble the device! In the event of a defect, please contact your dealer. They will contact the Service Center and can arrange the return of this device for repair if necessary.
• Do not immerse the unit in water! ?
• Do not expose the device to impacts, vibrations, dust, constant high temperatures or excessive humidity. This can result in malfunctions, short-circuits or damage to the batteries and components.
• Use only the recommended batteries. Always replace weak or empty batteries with a new, complete set of batteries at full capacity. Do not use batteries from different brands or types or with different capacities. Remove batteries from the device if it is not to be used for a longer period of time! ?
• Do not use rechargeable batteries (accumulators).

NOTICE Risk of voltage damage!

The manufacturer is not liable for damage related to improperly installed batteries!

Parts Overview and Scope of Delivery

Illustration 1 shows two views of the thermo-hygro sensor. The front view displays the screen with time, temperature, humidity, and climate indicator. The rear view shows ventilation slots, buttons (SET, UP, DOWN), and the battery compartment with a removable stand.

• 1 Housing
• 2 Display
• 3 Ventilation slots
• 4 SET button
• 5 UP button
• 6 DOWN buttons
• 7 Battery compartment with cover
• 8 Stand, removable

Scope of delivery: 2x Thermo-hygro sensor (A), 4x Button cell type CR2032.

Screen Displays

Illustration 2 details the display elements:

• 13 AM/PM information in 12-hour time mode
• 14 Climate Indicator Icon (smiley faces)
• 15 Time (hours:minutes)
• 16 Air humidity (in %)
• 17 Temperature (selectable in °C/°F)
• 18 Radio-controlled clock status display with info 'DST' (only when daylight saving time is active)

Setting Up Power Supply

1. Remove the battery compartment cover.
2. First use: Remove the transparent plastic tab. Battery change: Insert battery(ies) into the battery compartment. Ensure that the battery polarity (+/-) is correct.
3. Replace the battery compartment cover.

Automatic Time Setting

After the power has been restored, the unit automatically searches for the radio signal. This process takes approximately 3-8 minutes. If the radio signal is received correctly, the date and time are set automatically and the reception symbol is displayed.

If no radio signal has been received, proceed as follows:

1. Press the DOWN button for approx. 2 seconds to initiate the reception of the radio signal again.
2. Press the DOWN button once again for approx. 2 seconds to stop the reception of the radio signal.
3. If still no radio signal is received, the time must be set manually.

Manual Time Adjustment

1. In normal display mode, press the SET button for about 3 seconds to enter the time settings mode.
2. The digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press the SET button to confirm and switch to the next setting.
5. Sequence of the settings: Time offset > Hours > Minutes > Year > Month > Day.
6. Finally, press the SET button to save the settings and exit settings mode.

Automatic Measurement Display

Once the power is established, the readings for the current environment are displayed on the unit.

Clima Indicator

The climate indicator is a visual display based on air temperature and humidity to determine the level of comfort.

• Dry (left symbol): Humidity <40%, temperature >20 to <27°C ?
• Optimal (centered symbol): Humidity 40% to 70%, temperature 21°C to 26°C ?
• Humid (right symbol): Humidity >70%, temperature <20°C or >27°C ?

Note: The comfort display may vary at the same temperature, depending on the humidity.

Display Change

• In normal display mode, press the SET button to switch between time and date.
• In normal display mode, press the DOWN button to toggle between °C and °F when displaying the temperature unit.
• In the normal display mode, press the UP key to switch between the 12-hour and 24-hour time display.

Disposal

Dispose of the packaging materials according to its type. Information on proper disposal can be obtained from the municipal waste disposal service provider or environmental agency. ?️

Do not dispose of electronic devices in the household garbage! ⚡ According to the European Directive 2012/19/EU on Waste Electrical and Electronic Equipment and its transposition into national law, used electrical equipment must be collected separately and recycled in an environmentally sound manner.

Batteries and rechargeable batteries must not be disposed of with household waste. ? You are legally obliged to return used batteries and accumulators and can return them after use either at our sales outlet or in the immediate vicinity (e.g. in the trade or in municipal collection points) free of charge. Batteries and accumulators are marked with a crossed-out dustbin and the chemical symbol of the pollutant, "Cd" stands for cadmium, "Hg" stands for mercury and "Pb" stands for lead.

Warranty

The regular warranty period is 2 years and starts on the day of purchase. To benefit from an extended voluntary warranty period as indicated on the gift box, registration on our website is required.

You can consult the full guarantee terms as well as information on extending the guarantee period and details of our services at www.bresser.de/warranty_terms.

CE Declaration of Conformity

Bresser GmbH hereby declares that the radio equipment type with item number 7000017 is in compliance with Directive 2014/53/EU. The full text of the CE Declaration of Conformity is available at the following web address: www.bresser.de/download/7000017/CE/7000017_CE.pdf.

Technical Data

• Power supply: 2x CR2032 button cell (per station)
• Temperature unit: °C or °F selectable
• Temperature display range: -9.9°C to +50°C
• Humidity display range: rH 1% to 99%
• Measurement accuracy for temperature:
• -40°C ~ -20°C: ± 4°C
• -20°C ~ 0°C: ± 2°C
• 0°C ~ +50°C: ±1°C
• ±4°C if the temperature is above 50°C
• Measurement accuracy for humidity:
• ±5% from 35% to 75%
• ±10% from 20% to 35% & 75% to 95%.