Signature Design by Ashley Stool Assembly Instructions

Important Safety Information

Please read the following guidelines carefully before assembling furniture!

• Note: Your unit may look different in appearance from the one shown in the illustrations on this instruction sheet.
• Follow assembly steps in order. Do not skip any steps.
• For products with electrical components (e.g., lamps, lights), ensure power is disconnected before assembly. Do not twist wires during assembly.
• When assembling furniture with shelves or TV stands, do not stand on lower shelves to install upper shelves; use a ladder.
• Do not stand on tables like coffee tables, end tables, or dining tables, as they are not designed to support human weight.
• If assembly requires two or more people, do not attempt alone for your safety.
• Use appropriate tools for assembly.
• Carefully check packaging for small parts. Contact your local retailer for missing parts; do not substitute with other parts.
• Periodically check to ensure all connections (screws, bolts, etc.) are tight.
• Keep these assembly instructions for future reference.
• Handle glass and mirrors with care during installation to prevent injury from broken glass or mirrors. Do not assemble large glass or mirrors alone.
• Crucial Assembly Note: Do not tighten any bolts until all bolts have been started.
• Once assembly is complete, level the stool and tighten all bolts securely using the allen wrench.

Parts List

• Part A: Base Panel [quantity 1]
• Part B: Leg Assembly [quantity 2]
• Part C: Leg Assembly [quantity 2]
• Part D: Bolt [size 1/4 inch x 40mm] [quantity 4]
• Part E: Washer [quantity 1]
• Part F: Screw [size #4 x 50mm] [quantity 4]

Note: The diagrams suggest more quantities of parts D and E may be required than listed. Please refer to the diagrams for visual guidance.

Assembly Steps

1. Step 1: Begin with the base panel (Part A).
2. Step 2: Attach the two leg assemblies (Part B) to the base panel (Part A). The diagram shows four connection points, each secured with a bolt (Part D) and a washer (Part E). Do not fully tighten the bolts at this stage.
3. Step 3: Secure the leg assemblies further by attaching screws (Part F) into the designated points on the leg structures. The diagram indicates these connections also use bolts (Part D) and washers (Part E).
4. Step 4: With all parts assembled, carefully place the stool upright on a level surface. Ensure the stool is stable and then tighten all bolts and screws securely using the appropriate allen wrench.

Replacement Parts & Support

For replacement parts or further assistance, please contact:

• Email: RTAParts@ashleyfurniture.com
• Website: www.ashleyfurniture.parts
• Phone: 1-844-966-0809