Rasonic Aroma Mood Light Speaker

1. Important Safeguards

When using the appliance, please follow the below safety precautions:

1. To avoid danger, use the appliance only as described in the operation manual. Do not use it or any part outdoors or out of the intended purpose. Misuse can cause potential injury.
2. Do not press two or more buttons at the same time.
3. Unplug the appliance during a thunderstorm or when not in use for a long time.
4. Do not attempt to modify the appliance by yourself or repair with any unauthorized parts, otherwise it will cause hazards and the warranty becomes invalid.
5. Make sure you are using the correct power source. Connect the appliance to the correct power connector and wall outlet according to the instructions in the manual.
6. The appliance is not waterproof and must be kept dry. Never immerse the appliance, USB cable or plug in water or let them wet, it can cause electric shock or fire.
7. The aroma diffuser cannot be turned upside down.
8. Pure essential oils from plants must be used, and the essential oils can be diluted with carrier oil. Water-soluble essential oils cannot be used.
9. The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
10. Children should be supervised not to play with the appliance. Keep the appliance and its USB cable out of reach of children.
11. Unplug the appliance during installing the aroma bottle and cleaning.
12. Do not expose the appliance or battery to excessive temperatures.
13. The appliance contains non-rechargeable battery; the battery is not to be recharged. Do not use modified or damaged battery. Be aware of the risk of terminals of battery-operated appliance or battery being short-circuited by metal object. If the appliance is to be stored unused for a long period, the battery should be removed.
14. Exhausted battery is to be removed from the appliance. Wind it with adhesive tape and keep it properly insulated before disposal of the battery.
15. If the battery leaks and the leaked substance comes into contact with the skin or clothing, rinse the contact area thoroughly with clean running water. If in contact with eyes, rinse thoroughly with plenty of clean running water and seek medical attention immediately.
16. WARNING: Keep the battery out of reach of children. Swallowing can lead to chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2 hours of ingestion. Seek medical attention immediately.

2. Package Details

• Aroma Mood Light Speaker x 1
• USB Cable x 1
• Operation Manual x 1

3. Setting Up

1. The appliance requires a main supply of 25W transformer. Using a transformer lower than 25W, some functions of the appliance may not able to work properly.
2. Connect one end of the USB cable to the power input port (ii) of the appliance, the other end to a 25W transformer, and then plug it into the wall socket.
3. When the appliance is powered on, user can connect one end of the USB cable to the power output port (i) of the appliance, the other end to other external devices offering 1A power source for their use.
   • (i) Output DC 5V, 1A
   • (ii) Input DC 9V, 2.77A
4. A battery is inserted at the bottom of the appliance to provide back-up power source. Take out the battery isolator stripe from the battery compartment after time is set with socket power. Battery is only to record the clock and alarm setting and ensure their operation unaffected by power outages. When the power is restored, the clock and alarm do not need to be reset. If it is not connected to a proper power source, the clock time will not be displayed and the alarm will not sound. The appliance cannot be operated when no connection with 25W or higher transformer.

   Backup battery: 1 X CR2032

5. For the first time using, user must set the clock before using other functions.

4. Product Description

4.1 Diffuser

4.2 Main unit

5. Operation Instructions

1. Light

Turn on/off the light

Press the [light] button to cycle through different light modes and turn off the light. The sequence is: White light -> Mood light -> Off.

Set the light level

White light: The default brightness level is 3, with 10 levels available. Press the [+] or [-] buttons to adjust the brightness. Due to the many dimming levels and delicate changes, the brightness may not change significantly with each press. Long-pressing the [+] or [-] buttons allows for quick brightness adjustment.

Mood Light: The default setting is an automatic color loop with 7 sets of color combinations. Press the [+] or [-] buttons to fix the mood light to a selected color combination. To switch from a fixed color mode back to the automatic loop, press the [On/Off] button to return to mood light mode.

2. Bluetooth Speaker

(When the Bluetooth speaker is active, you cannot set the clock, alarm, switch between 12/24 hour formats, or activate the alarm function.)

Turn on the Bluetooth

Long press the [BT] button for 2 seconds to turn on Bluetooth. A prompt sound will play. Connecting to the Bluetooth device (AROMUSE) will also trigger a prompt sound upon successful connection and disconnection.

Turn off the Bluetooth

Long press the [BT] button for 2 seconds.

Play/pause

Press the [BT] button to play or pause music.

Previous song

Press the [Previous] button ⏮️ to play the previous song.

Next song

Press the [Next] button ⏭️ to play the next song.

Set the volume

Press the [Volume Up] ? and [Volume Down] ? buttons to adjust the volume.

3. White Noise

(When white noise is active, you cannot set the clock, alarm, switch between 12/24 hour formats, or activate the alarm function.)

Turn on/off the white noise

Press the [White Noise] button ⚙️ to turn the white noise on and off.

Previous/next sound track

Press the [Previous] ⏮️ and [Next] ⏭️ buttons to play the previous or next sound track. (There are 10 preset sound tracks.)

Set the volume

Press the [Volume Up] ? and [Volume Down] ? buttons to adjust the volume.

4. Timer

Activate the timer

When the light or Bluetooth/white noise is on, press the [Timer] button to activate the timer.

Set the timer

Press the [Timer] button to cycle through timer settings: 30 minutes -> 60 minutes -> 90 minutes -> Off. The corresponding indicator will light up.

Deactivate the timer

Press the [Timer] button to deactivate the timer. The timer will also deactivate if the light or Bluetooth/white noise is turned off.

5. Clock

(When setting the clock, you cannot use the Bluetooth speaker or white noise.)

Switch 12H/24H

Press the [12H/24H] button to switch between 12-hour and 24-hour clock formats. AM or PM will be displayed in 12-hour format; it will not be displayed in 24-hour format.

Set the clock time

Long press the [Time Setting] button for 2 seconds. When the hour digit flashes, press [+] or [-] to set the hour, then press the [Time Setting] button to confirm. When the minute digit flashes, press [+] or [-] to set the minute, then press the [Time Setting] button to confirm. If the setting is left idle for 30 seconds, the digit will stop flashing, the setting will be cancelled, and the last clock setting will be displayed.

6. Alarm

(When setting the alarm, you cannot use the Bluetooth speaker or white noise.)

Activate or deactivate the alarm

When the clock is set, press the [Alarm] button ? to activate the alarm. The corresponding icon will appear on the display. The alarm time will show for 3 seconds and then return to the clock display. Press the [Alarm] button again to deactivate the alarm; the corresponding icon will not be displayed.

Set the alarm time, sound, volume and duration

Long press the [Alarm] button for 2 seconds until the hour digit flashes. Press [+] or [-] to set the hour, then press the [Alarm] button to set the minute digit, and press the [Alarm] button to confirm.

It will switch to alarm sound setting. Press [+] or [-] to select the alarm sound (10 sounds available). Press the [Alarm] button to confirm.

It will switch to alarm volume setting. Press [+] or [-] to set the alarm volume (20 volume levels available). Press the [Alarm] button to confirm.

It will switch to set the wake-up light timer. The default wake-up light timer is 10 minutes before the alarm time. Press [+] or [-] to set the wake-up light timer (5 mins -> 10 mins -> 20 mins -> 30 mins -> 60 mins). Press the [Alarm] button to confirm, and the clock time will be shown again.

Sunrise simulation

When the wake-up light timer is set, the light can simulate a sunrise by gradually increasing its intensity, reaching the highest intensity at the alarm time. The corresponding icon appears and flashes on the display while the lamp's intensity is increasing.

Snooze

Long press the [Light] button for 2 seconds to turn off the light. Once the alarm rings, press any button (except the [Light] button) to turn off the lamp and alarm. The lamp and alarm will turn on again after 5 minutes.

Cancel the alarm

The alarm will be stopped after 5 minutes and the light will turn off. Alternatively, press the [Alarm] button to turn off the alarm.

7. Diffuser

Set up the diffuser

Lift the diffuser from the top of the lamp, unscrew the aroma bottle, add essential oil, and tighten it. Align the vertical mark on the diffuser with the triangle mark ▲ on the top of the lamp and insert it back.

Turn on/off the diffuser

Press the [ON/OFF] button to turn the diffuser on and off.

Set the atomization level

Default mode is Low. Press the [Mode] button to switch the atomization level: Low -> Medium -> High. The indicator corresponding to the intensity level will light up.

• Low mode: Diffuser works for 10 seconds and stops for 90 seconds.
• Medium mode: Diffuser works for 10 seconds and stops for 60 seconds.
• High mode: Diffuser works for 10 seconds and stops for 30 seconds.

Set the diffuser timer

The default timer is 4 hours, but there is no corresponding indicator. Press the [Timer] button to cycle through timer settings: 1h -> 2h -> 3h -> 4h. The indicator corresponding to the timer will light up, except for 4h.

Clean the diffuser timer

When using the aroma diffuser again after a long period of disuse, or when changing the type of essential oil, it must be cleaned according to the following steps:

1. Step 1: Pour approximately 10 ml of 75% purity alcohol into an empty essential oil bottle.
2. Step 2: Place the aroma diffuser back into the appliance, turn on the high mode, and turn off the aroma diffuser 20 minutes after atomization appears.
3. Step 3: Pour away the remaining alcohol from the essential oil bottle and refill it with essential oil for normal use.

8. Brightness of Display

The display brightness is automatically adjusted according to the ambient brightness. The brighter the environment, the brighter the display will be; and the darker the environment, the display will darken accordingly.

6. Specification

7. Special Avowal

1. The content in this operation manual has been checked. The company reserves the right to interpret any printing errors or misunderstandings in the content.
2. If there are technical improvements to the appliance, this operation manual will be updated in a new version without prior notice. The product appearance and specifications are subject to the manufacturer's information.
3. An electronic copy of this operation manual can be sent by email upon request. For inquiries, please call Shun Hing Electric Works and Engineering Co., Ltd. at 2861 2767.

8. After Sales Service

Shun Hing Electric Works & Engineering Co., Ltd. ("The Company") authorizes Shun Hing Electric Service Centre Ltd. (“SHESC”) to offer 1 year warranty service to the product, commencing from the date of purchase invoice or redemption voucher. SHESC reserves the right to change warranty terms without prior notice. For details of warranty terms, please refer to our website.

Contact Information:

Shun Hing Electric Works and Engineering Co., Ltd.
Office: 9/F, Peninsula Centre, 67 Mody Road, Tsimshatsui East, Kowloon, Hong Kong
Tel: 2861 2767
Website: http://www.rasonic.hk
Email: shew@shunhinggroup.com

Maintenance and Repair Service:

Shun Hing Electric Service Centre Ltd.
11/F, Shun Hing Centre, 2 Shing Yiu Street, Kwai Chung, N.T. HK
Tel: 2406 5666
Fax: 2408 0316
Website: https://www.shunhing-service.com/en

For the latest information of Hong Kong and Macau service centres, please visit: https://www.shunhing-service.com/zh