Installation Statement
1. Please read the instruction manual carefully before installation and follow the instructions.
2. To avoid the risk of electric shock, please make sure to turn off the power before installation and maintenance.
3. This lamp is only suitable for indoor installation (not for wet environments).
Components
Illustration showing the components of the 3D printed table lamp. It includes a lampshade, a power cord with a switch, an E27 lamp holder, fixing screws, and a solid wood base.
- 3D printed lampshade
- Power cord with switch
- E27 lamp holder (maximum power 25W)
- Fixing screws
- Solid wood base
Installation Diagram
Step 1: Install Light Source
Keep the power off and install the light source properly.
[Diagram: Power cord connected to base, with a light bulb being screwed into the lamp holder.]
Step 2: Secure Lampshade
Secure the lampshade to the base.
[Diagram: The base with the lamp holder and bulb is shown. An arrow indicates the 3D printed lampshade being placed onto the assembly.]
Step 3: Connect and Enjoy
Plug in the power cord and turn on the switch, and enjoy the artistic atmosphere created by the 3D printed lamp.
[Diagram: The fully assembled lamp is shown plugged in and illuminated.]
Precautions
Warning
Do not modify the lamp or replace its parts at will to avoid accidents such as electric shock and fire.
Attention
- Please use the lamp within the allowed voltage range. Using it with a voltage higher than the specified value may cause the lamp to burn out and lead to accidents such as fires.
- This lamp is a general indoor lamp. Please do not use it in direct sunlight, damp places, or areas where corrosive gases are generated.
- The light source of this lamp is replaceable. When the light source reaches the end of its lifespan, simply replace the light source of the lamp.
- Do not apply excessive force to the lamp, as it may cause damage.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Maintenance and Repair
- When the lamp needs to be cleaned, please first unscrew and remove the lampshade. Wipe it with a soft cloth dampened with clean water and wrung dry, and then dry it with a dry cloth.
- Do not use detergents, organic solvents, or insecticides to wipe or spray on the lamp. This may cause discoloration, deterioration, reduced strength, or damage to the lamp.
