Paradox K32LCD/K32LX LCD Keypad Quick Start
Overview
The Paradox K32LCD/K32LX LCD Keypad provides system status and messages. Key features include:
- Quick menu programming: Press once + [MASTER CODE].
- AC light: Indicates power status (ON = power ON; OFF = power OFF).
- StayD light: Indicates StayD status (ON = StayD ON; OFF = StayD OFF).
- RX/TX logo: Present on the K32LX model only.
The keypad features an LCD screen for displaying system status and messages, arrow keys for navigating menus, backlight settings (press and hold), and chime programming (press and hold).
How to Arm
NOTE: To arm with StayD enabled, refer to the StayD User Manual, available at paradox.com > StayD. For more information about StayD, contact your installer.
Arming When Exiting (Regular Arm)
To arm your system when exiting:
| Step | Description |
|---|---|
| 1. | Close all zones in desired partition. |
| 2. | Press [ARM] and enter your [ACCESS CODE]. |
Arming When Staying (Stay/Sleep Arm)
To arm your system when staying:
| Step | Description |
|---|---|
| 1. | Press [STAY] for Stay arming or [SLEEP] for Sleep arming, and enter your [ACCESS CODE]. |
| 2. | Select the desired partition (1 or 2). For both, press one, then the other after the beep. |
How to Disarm
To disarm your system when entering:
| Step | Description |
|---|---|
| 1. | Press [OFF] and enter your [ACCESS CODE]. |
| 2. | Select the desired partition (1 or 2). For both, press one, then the other after the beep. |
Panic Keys
To send a silent or audible alarm to your security company, press and hold one of the key combinations listed below, for two seconds.
| Panic Alarm | Key Combination |
|---|---|
| Police | [1] & [3] |
| Medical | [4] & [6] |
| Fire | [7] & [9] |
Alarm Memory Display
To view the alarms that occurred during the last armed period:
| Step | Description |
|---|---|
| 1. | Disarm the system. |
| 2. | Press [MEM]. All zones that were breached during the last armed period will be displayed. Use the arrow keys to view zones. |
| 3. | Press [ENTER] to save and exit. |
Trouble Display
The LCD screen will display all troubles when they occur. To view and clear troubles:
| Step | Description |
|---|---|
| 1. | Press [TBL]. |
| 2. | Scroll through the list of troubles using the arrow keys. Refer to the MGSP User Guide for trouble descriptions and instructions. |
| 3. | Perform the recommended repair instruction to clear the trouble. If no instructions are given, contact your security company. |
| 4. | Press [CLEAR] to exit. |
How to Bypass Zones
When a zone is bypassed, it remains unarmed once the corresponding area is armed. To bypass zones:
| Step | Description |
|---|---|
| 1. | Press [BYP]. |
| 2. | Enter your [ACCESS CODE]. |
| 3. | Select the zone you want to bypass by entering the zone number, e.g., zone 3 = 03). |
| 4. | Press [ENTER]. |
