Important Record Keeping
Retain this card, a copy of your receipt, and your 24-digit serial number for your records.
NEED HELP?
Please visit our “support and contact” section on www.hover-1.com.
Do not return to store. We're here to help!
Getting Started with Your Hover-1 Blast
BEFORE FIRST USE, PLEASE FULLY CHARGE YOUR HOVER-1 BLAST.
The Blast is fully charged when the light on the charger itself turns from red to green.
LOCATING YOUR HOVER-1 BLAST SERIAL NUMBER
Two stickers with a corresponding serial number are affixed to the bottom of the unit. Carefully remove one sticker and affix it onto the designated place in your Blast manual.
CALIBRATING YOUR HOVER-1 BLAST
If your Blast is vibrating, spinning, uneven, leaning, or unbalanced, a quick calibration is necessary.
- First, place the Blast on a flat, horizontal surface, such as the floor or a table, ensuring it is powered off and not plugged into the charger.
- Press and hold the power button for 5-10 seconds.
- When your Blast starts beeping, release the power button.
- To complete calibration, power off your Blast and then back on. The beeping will stop, and the board is now calibrated. It is recommended to recalibrate your Blast after every few rides to maintain smooth operation.
