Juno Trac Adapter Installation Instructions

FIXTURE INSTALLATION

1. Step 1

   Find the latch and the polarity line. Align parts as shown and insert the adapter box into the track.

   Fig. 1: Diagram showing the adapter box being inserted into a track, with labels for LATCH and POLARITY LINE.

2. Step 2

   Pull down the latch while rotating the adapter box 90 degrees clockwise.

   Fig. 2: Diagram illustrating the process of pulling the latch and rotating the adapter box clockwise.

3. Step 3

   Final Position: Latch snaps into place between extrusion rails. Arrows on latch point toward the polarity line.

   Fig. 3: Diagram showing the adapter box in its final position within the track, with arrows on the latch indicating the polarity line.

SECOND CIRCUIT POSITIONING

1. Step 1

   Raise the contact marked "P" (on switch side) by inserting a thin screwdriver blade under the contact. Pull up into position as shown.

   Fig. 4: Diagram showing a thin screwdriver blade lifting the 'P' contact into position.

2. Step 2

   Insert contact support (supplied with 2-circuit Trac section) by tilting and snapping into position under the "P" contact as shown.

   Fig. 5: Diagram illustrating the insertion of the contact support under the 'P' contact.

3. Step 3

   Ensure contact support is snapped and locked into position. Follow instructions for inserting into track.

   Fig. 6: Diagram showing the contact support in its final, snapped, and locked position.

TROUBLESHOOTING

Diagrammatic Explanations for Troubleshooting:

• Fig. 7: Single Circuit Position (Used with T, TU, and R Series Track)

  • ✔️ Correct: Shows proper contact alignment.
  • ❌ Incorrect: Shows a bent contact.
  Fig. 7: Visual comparison of correct and incorrect single circuit contact positioning, highlighting bent contacts.

• Fig. 8: Two Circuit Position (Used with TU Series Track)

  • ✔️ Correct: Shows proper contact alignment.
  • ❌ Incorrect: Shows a bent contact.
  Fig. 8: Visual comparison of correct and incorrect two circuit contact positioning, highlighting bent contacts.

• Fig. 9: Switch Operation

  • Shows the adapter switch in the "Off" position.
  • Instruction to "Move Switch To 'On' Position".
  • Shows the adapter switch in the "On" position.
  Fig. 9: Illustration of the adapter's power switch, showing both "Off" and "On" states and the action to change it.