ASSEMBLY INSTRUCTIONS
ITEM NO: 194840316879
ACCENT CHAIR
Legs and hardware are stored in the bottom of the seat. Please take them out for assembly.
Note: Do not use power tools for assembly. Power tools increase the risk of over-tightening, which can lead to splitting or cracking the wood.
Parts List
| PART | DRAWING | DESCRIPTION | QTY | PART | DRAWING | DESCRIPTION | QTY |
|---|---|---|---|---|---|---|---|
| A | [Seat Drawing] | Seat | 1 PC | 1 | [Bolt Drawing] | Bolt Ø5/16"x2-3/16" | 8 PCS |
| B | [Front Wooden Leg Drawing] | Front Wooden Leg 14-1/4"x2"x2" | 2 PCS | 2 | [Spring Washer Drawing] | Spring Washer Ø5/16" | 8 PCS |
| C | [Rear Wooden Leg Drawing] | Rear Wooden Leg 13-1/2"x2"x1-1/2" | 2 PCS | 3 | [Flat Washer Drawing] | Flat Washer Ø5/16"x3/4" | 8 PCS |
| 4 | [Allen Key Drawing] | Allen Key M4 | 1 PC |
STEP 1:
Attach the legs to the seat. The diagram shows the seat with attachment points. Ensure you have the correct hardware quantities: 8 bolts, 8 spring washers, 8 flat washers, and 1 Allen key.
[Diagram showing seat and leg attachment points with hardware quantities]
STEP 2:
Continue assembling the chair by attaching the rear legs to the seat assembly using the provided hardware (parts 4, 1, 2, 3).
[Diagram showing rear leg attachment to the seat assembly]
COMPLETE
[Image of the fully assembled Accent Chair]
Care Instruction for Textured Furniture:
In order to maintain the original appearance of your textured furniture, please follow below simple care procedures:
- ⚠️ Avoid exposing furniture directly to sunlight or heating and air conditioning outlets. Sunlight and/or exposure to heating and air conditioning outlets will fade/damage the texture.
- Vacuum or wipe with a soft cloth to remove dust.
- Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-tighten if necessary.
- For use on wooden floors, hard surfaces, or carpets, it is recommended to install protective pads under all legs and supports to avoid/prevent damages, scratches, and discoloration.
