Canopy Instructions For Installation

Contents

1. One hoop style canopy netting with hanging ring attached.
2. One hoop
3. One hook screw
4. One plastic anchor

Set Up

1. Remove contents from the poly bag.
2. Shake out the canopy, holding the metal ring at the top.
3. Turn over and see ribbon ties in circular pattern.
4. Place the hoop around the circle pattern and tie the hoop to the netting using the ribbon ties.
5. Measure and mark a center point over the bed, ideally with pencil.
6. Screw hook hardware into the ceiling.
7. Turn canopy over and grip the metal ring on top of the canopy. Hang canopy from ceiling hook and spread mosquito netting around the bed. Adjust to desired look.

Note: For a ceiling that requires an anchor, use a 3/16" drill bit or nails to make a hole before inserting the plastic anchor. Then screw in the hook screw.

SAFETY WARNINGS – PLEASE READ BEFORE USING PRODUCT

• CAUTION: When draping the canopy over children's slumber areas, please be advised to anchor the fabric. Restless children may become entangles in fabric that is not anchored.
• Before use: An adult should inspect the assembled canopy; if the product appears worn, cracked or broken in any way, discontinue use and discard immediately.
• Avoid sharp or pointy objects that will snag fabric. The fabric should not be pulled as the seams may part. The canopy should not be climbed on.
• Always keep the canopy away from open flames.