Hanwha Techwin TID-600R Intercom Accessories

Product Overview

SBC-165W Skin Cover

The SBC-165W is a skin cover that allows the color of the TID-600R Intercom to be changed to white.

SBS-165TM Tilt Mount

The SBS-165TM is a mount for installing the TID-600R Intercom on a wall at a tilted angle of 30°.

SHS-165F Flush Mount

The SHS-165F is a mount for installing the TID-600R Intercom camera in a buried (flush) type installation.

Installation Guides

Installation of SBC-165W Skin Cover

Step 1: Install the skin cover from the Intercom's front, as if covering it.

Step 2: To remove the installed skin cover, take off the screw at the bottom of the Intercom and separate the Intercom's main body from the mount plate.

Step 3: As shown in the figure, separate it while spreading the skin cover to both ends.

Installation of SBS-165TM Tilt Mount

Step 1: First, attach the Intercom's mount plate to the tilt mount on the wall, then connect it to the Intercom's main body.

Important Consideration: Before installing the tilt mount on the wall, it is necessary to consider the orientation of the Intercom's front side. The up and down orientation of the tilt mount changes based on the installation direction. Check the arrow indicator on the side of the tilt mount for correct wall alignment.

Installation of SHS-165F Flush Mount

Step 1: After attaching the Intercom to the flush mount, install it on the wall.

Note: Before attaching the Intercom, confirm the correct up and down orientation of the flush mount body.

Step 2: When the installation of the flush mount on the wall is completed, attach the flush mount cover.

Step 3: To remove the flush mount cover, separate it by pulling the area of the gap on both sides while pressing the front part.